Using The Headset - Plantronics T10 User Manual

STEP 1
SETUP
Connect the Telephone Line Jack
16
using the Line Cord . Allow the unit to initialise for 45
17
seconds before use.
Turn the T10 base over and insert the Headset Holder
Set the Tone/Pulse Switch to match your phone service (usually
5
tone). If you are not sure, call your local telephone provider.
Set the Ringer Volume Control
6
preferred level.
Plug the Headset Cord into the Headset Jack
18
To maximise the effective of your T10 in your country, set the
Flash Timing Switch to match your local requirements, or try
4
each of the three settings and select the one that works best.
(See the Flash Feature section for more information on the Flash
Feature itself).
to the telephone wall outlet
.
1
for incoming calls to your
.
10
6
STEP 2

USING THE HEADSET

The Headset included with the T10 Headset Telephone can be
G
used with the Adjustable Headband or with one of the
Earloops.
HEADBAND USE
Snap the Adjustable Headband
Assembly . Press the Ear Cushion Assembly
21
Assembly , aligning the notch in the ring with the Voice Boom
21
Place the Headset on either ear and adjust the Headset to a
comfortable position by moving the Adjustable Headband
Position the Voice Boom
EARLOOP USE
Press the Pivot Ball Ring
Insert one of the Earloops
need to try each size to find the most comfortable fit. Slip the
earloop over your ear and position the Voice Boom near the
corner of your mouth.
CLOTHING CLIP
The Clothing Clip
cord. Attach the clip to your clothing at about chest level. Allow
enough slack in the cord (approximately 6 inches) to permit your
head to move without pulling on the Headset or the Clothing Clip.
You are now ready to make or receive calls.
into the back of the Headset
20
onto the Headset
25
near the corner of your mouth.
22
onto the Headset Assembly
24
into the Pivot Ball. You may
23
keeps the Headset free from the weight of the
19
7
A
.
22
.
20
B
.
21
C
D