Plantronics Savi W710A-M, W720A-M - Multi-Device Wireless Headset System Quick Start Guide

Device Оverview

1. Decrease volume Short press –
2. Answer/end call Short press
3. Mute Short press
4. Increase volume Short press +

Flash While on call, long press volume up + or volume down – for 1.5 seconds, will put call on hold and answer another.

For your safety, do not use headset at high volumes for extended periods of time. Doing so can cause hearing loss. Always listen at moderate levels. For more information on headsets and hearing, visit plantronics.com/healthandsafety.

Please refer to the separate safety instructions for important product safety information prior to installation or use of the product.

Savi W710A/W720A has a WO2A base and a WH300A/Savi W710/W720 has a WO2 base and a WH300/WH350 WH350A headset.

Headset

Customise and charge

1. Attach charging cradle to base.
   
2. Plug one end of power supply into power jack on back of the base and other end into working power outlet.
   
3. To charge, dock headset in base, minimum of 20 minutes.
   

Desk phone

Connect and call

1. Choose desk phone setup A, B or C and connect cables.
   1. Desk phone (standard)
      
   2. Desk phone + HL10 lifter (sold separately)
      See user guide at plantronics.com/accessories
      
   3. Desk phone + EHS cable (sold separately)
      See user guide at plantronics.com/accessories
      
2. While wearing headset, short press base desk phone button.
   
   NOTE If you don't have remote call control through a lifter (HL10) or cable (EHS), manually remove desk phone handset before each call.
3. If you do not hear a dial tone, open side panel and adjust middle configuration switch (A–G) until you do. Default setting A works for majority of desk phones.
   
4. Dial test call from desk phone.
5. End call by pressing headset call control button.
   

Mobile

Connect and call

1. Press down and hold Bluetooth pairing button (4 seconds) on Savi base until indicator LED flashes red and blue.
   
2. Place Bluetooth mobile phone into search mode. Select SAVI 7xx from the list of found devices.
   
3. If prompted by mobile phone, type 0000 as passcode. Bluetooth indicator LED on base will turn solid blue when base has an active connection with mobile phone.
   
4. While wearing headset, short press base mobile button.
   
5. Dial test call from mobile phone.
6. End call by pressing headset call control button.
   

Computer

Connect and call

1. Connect USB cable.
   
2. While wearing headset, short press base computer button.
   
3. Dial test call from computer softphone.
4. End call by pressing headset call control button.
   

NEED MORE HELP?

Technical, Product support
plantronics.com/support

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Plantronics Savi W710A-M, W720A-M - Multi-Device Wireless Headset System Quick Start Guide