2.2 Product Over view 3.1 Unpacking and Inspection (parallel model available) (parallel model available) 3.2 Preparation (2KVA/3KVA) 3.3 Mounting the Unit...
Model Typical Battery Torque Cable Wire Size Dimensions (PWM) Amperage capacity value D (mm) L (mm) 1*6AWG 29.2 2~ 3 Nm 2KVA 100AH 23.8 2*10AWG 33.2 1*4AWG 100AH 2~ 3 Nm 3KVA 100A 200AH 29.2 2*8AWG 3.4 Batter y Connection...
Page 6
3.5 AC Input/Output Connection 3.5 PV Connection...
Page 7
3.8 Communication Connection 3.9 Dr y Contact Signal 3.7 Final Assembly...
Page 8
3.10 Parallel installation(Only 4KVA/5KVA available) 3.10.1 Parallel board installation (Following steps just for some customers have installed the inverter,but later need to increase the parallel connection function, so need install the parallel board by themselves)
Page 9
3.10.2 Mouting the Unit 3 inverters in parallel: 3.10.3 Parallel Operation in Single phase (Only 4KVA/5KVA available) 2 inverters in parallel:...
Page 10
4 inverters in parallel: 6 inverters in parallel: 5 inverters in parallel:...
Page 11
3.10.4 Parallel Commissioning 4 inverters group three phase Two inverter in one phase and only one inverter for the remaining phases: 3.10.5 Parallel operation in three phase (Only 4KVA/5KVA available) 3 inverters group three phase one inverter in eachphase:...
Page 12
5 inverters group three phase 6 inverters group three phase...
5kva3kva4kvaOff grid solar inverter with mppt controller 2kvaOff grid solar inverter with mppt controller 3kvaOff grid solar inverter with mppt controller 4kva...
Show all
Off grid solar inverter with mppt controller 5kvaOff grid solar inverter with pwm controller 1kvaOff grid solar inverter with pwm controller 2kvaOff grid solar inverter with pwm controller 3kva
Need help?
Do you have a question about the 2KVA and is the answer not in the manual?
Questions and answers