Canon MV750i E Service Manual page 119

1-21 Disassembly of LCD Hinge Unit - 2
(1) Remove a screw (f × 1), and detach the LCD FPC Ass'y.
<Note on Reassembling>
(1) If a service part of LCD FPC Ass'y is used, put "1" and "2", "3" and "4" on each other as illustrated in this order, and fasten them
with double face tape on the FPC. Then, fold back "5" and "6", and fasten them with double face tape on the FPC.
(2) Wind the LCD FPC Ass'y 2-1/2 turns at the illustrated status, and fasten the Switch section by screws. The FPC must not be wound
on other than the Switch section.
<Instruction for Supply>
(1) LCD FPC Ass'y winding section : Hanarl KS-50M (DY9-3047-000)
Instruction for Supply
Hanarl
KS-50M
Note on Reassembling (1)
Reversible Tape
1
Reversible Tape
3
4
Fold line
Note on Reassembling (2)
Wind 2 1 / turns
2
LCD FPC Ass'y
LCD FPC Ass'y
Reversible Tape
2
Reversible Tape
Fig. 22
MV750i E, MV730i E, MV700i E, MV700 E, MV690 E
5
Attach to match
the flexible cable
6
contour within error
of ±0.5 mm.
Folded part
Do not involve flexible cable when
tightening by screws.
25
DISASSEMBLING
f
2.5mm
Metal
M1.7
(1) - f
(1)
Switch section