Local Configuration; Ethernet Setup - Crestron TSW-560 Product Manual

Local Configuration

Refer to the following sections for information about configuring the device locally using the device
setup screens.

Ethernet Setup

Tap Ethernet Setup on the Setup screen to display the Ethernet Setup screen.
Ethernet Setup Screen
Use the Ethernet Setup screen to view the touch screen MAC and IP addresses, subnet mask
address, default router address, primary and secondary DNS addresses, hostname, and domain. A
Link indicator is provided to indicate the status of the Ethernet connection. (Green indicates that
the Ethernet connection is active.)
The following buttons are provided for configuring Ethernet settings:
Tap On or Off under DHCP Enable to turn DHCP (dynamic host configuration protocol) on
l
or off.
NOTE: DHCP is enabled on the touch screen by default.
If DHCP is turned off, tap Set Static IP Address Settings to enter static IP addresses
l
manually.
Tap Set Hostname to enter a new touch screen hostname using an on-screen keyboard.
l
Tap APPLY CHANGES to apply any new Ethernet settings to the touch screen and to stay in
l
setup mode.
Tap REBOOT to exit setup mode and reboot the touch screen.
l
6 • TSW-560, TSW-760, and TSW-1060 Product Manual — Doc. 7927K