Introduction; General Overview 1 - TPI DC710 Manual

Introduction

Thank you for purchasing TPI brand products. The TPI DC710
combustion analyser is state of the art and easy to use. Connect it to
your smart device and you are ready to perform combustion analysis.
The instrument is ruggedly constructed and comes with a 5 Year
Warranty*
* Warranty subject to annual service/re-calibration by TPI Europe Ltd
or an approved TPI Service Centre. Failure to ensure that
annual service/re-certification is carried out will nulify the 5 Year
Warranty and may lead to additional servicing costs when carried out.
General Overview
The TPI DC710 combustion analyser uses state of the art
electrochemical sensors. This sensor technology provides the longest
lasting most accurate and reliable means for performing combustion
tests. Your analyser will need to be serviced/re-certified annually.
The following guidelines will help prevent damage to your sensors and
keep your anlayser working and giving correct values:
• Always use the Mini Pump Protection Filter - see Page 11
• Always periodically check and replace the Mini Pump Protection
Filter as needed if it becomes blocked or
discoloured - see Appendix A
• Always make sure the in-line filter / water trap is installed
properly - see Appendix A
• Always periodically check and replace the in-line filter as
needed if this becomes saturated or discoloured- see Appendix A
• Always remove water or condensation from the inside of the
in-line filter / water trap assembly prior to performing tests - see
Appendix A
• Always use the optional oil filter (p/n A773) when performing
tests on oil burning equipment
Failure to monitor and perform the above may result in
SLOW and/or INCORRECT READINGS.
1