Table of Contents
Advertisement
Diagnosing Problems
Diagnosing Problems
Notify the network manager if the troubleshooting procedures indicate the problem is
software related or if the procedures do not correct the problem. Additional software
troubleshooting information is provided in the Network Access Software Problem
Solving Guide.
Use the following to diagnose and troubleshoot the DECserver problems:
•
Seven-segment display
•
System OK LED
•
Console port messages
A full list of seven-segment display codes are shown at the end of this chapter. Refer
to the Network Access Software Management Guide for the procedure to configure a
terminal to receive console port messages.
Compare the state of the Seven-Segment Display and the System OK LED with those
shown in Table A-1 and go to the section indicated for information on corrective
action.
On power up, the seven-segment display will show an "8". Allow about 3 minutes
to elapse before determining the state of the display.
A-2
NOTES
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DECserver 716 and is the answer not in the manual?
Questions and answers