Connecting Cables; Connecting The 8-Pin Mj Cable - Digital Networks DECserver 716 Installation And User Manual

Connecting Cables

Connecting Cables

This section describes how to connect cables to the DECserver.

Connecting the 8-Pin MJ Cable

Figure 5-2 shows how to connect the 8-Pin MJ cable to ports on the DECserver.
Figure 5-2: Connecting the 8-Pin MJ Cable
To connect the
Step
1
2
3
For cable lengths, refer to Chapter 4, Cabling Requirements. For information on
connectors, refer to Appendix B, Connector and Pin Assignments.
5-4 Connecting and Removing Cables and Adapters
2
1
cable, complete the following steps:
8-Pin MJ
Action
Align the release tab (1) on the cable plug with the connector (2) on the
module's serial port.
Insert the plug into the port connector (2) until the release tab snaps into
the locked position.
Connect the other end of the cable to an asynchronous device (PC comm
port, terminal, or modem).
350