Cisco ASR 907 Installing page 5

Hide thumbs Also See for ASR 907:

Table of Contents

Installing the Cisco ASR 907 Router

Figure 4: Installing the Chassis in a 300 mm ETSI Cabinet

Note

Step 3

Install the 8 or 12 (4 or 6 per side) 12-24 x 3/4-inch or 10-32 x 3/4-inch screws through the holes in the bracket

and into the threaded holes in the equipment rack posts.

Step 4

Use a tape measure and level to verify that the chassis is installed straight and level.

Installing Plenum A907-F2B-AIR-U Assembly and Chassis in the Rack

Procedure

Step 1

Position the air baffle and the side plate to the plenum. Secure the air baffle using a maximum torque of 11.5

in.-lb (1.3 N-m). See figure below.

The router can be mounted in an ETSI rack but the required bend radius for the cables and fibers

within the 300 mm ETSI specification cannot be maintained.

If you want to mount the router in ETSI cabinets, you need to have a custom-made cabinet front

door to meet the fiber bend radius requirement.

Installing Plenum A907-F2B-AIR-U Assembly and Chassis in the Rack

Installing the Cisco ASR 907 Router

Table of Contents