Cisco ASR 907 Installing page 25

Hide thumbs Also See for ASR 907:

Table of Contents

Installing the Cisco ASR 907 Router

Installing an Interface Module

Procedure

Step 1

Before inserting an interface module, make sure that the chassis is grounded.

Step 2

To insert the interface module, carefully align the edges of the interface module between the upper and lower

edges of the router slot.

Step 3

Carefully slide the interface module into the router slot until the interface module makes contact with the

backplane. The figure below shows how to install the interface module.

Figure 23: Inserting an Interface Module

Step 4

ITighten the locking thumbscrews on both sides of the interface module. The recommended maximum torque

is 5.5 in.-lb (.62 N-m).

Step 5

Connect all the cables to each interface module.

What to do next

Caution

Do not use interface module and power supply ejector handles to lift the chassis; using the handles to lift the

chassis can deform or damage the handles.

Note

Close all unused RJ-45, SFP, XFP, and QSFP ports on the interface module using the appropriate dust caps

to prevent dust from accumulating inside the cage. For information on dust caps, see

Installing an Interface Module

Installing Dust Caps

Installing the Cisco ASR 907 Router

Table of Contents