1. Service Instructions; Precautions For Disassembly/Adjustments - Minolta EP1080 Service Manual

1
SERVIC E INSTRUC TIO NS

1-1. PRECAUTIONS FOR DISASSEMBLY/ADJUSTMENTS

Observe the following precautions whenever servicing the copier.
•
Be sure to unplug the copier from the outlet before attempting to service the copier.
•
The basic rule is not to operate the copier anytime during disassembly.
If it is absolutely necessary to run the copier with its covers removed, use care not to allow your
clothing to be caught in revolving parts such as the Timing Belt and gears.
•
Be sure to use the Interlock Switch Actuating Jig whenever it is necessary to actuate the Interlock
Switch with the covers left open or removed.
•
Do not plug in or unplug print jacks on the Board or connect or disconnect the Board connectors
while power is being supplied to the copier.
•
Do not use flammable spray around the copier in operation.
•
The Magnet Roller of the Imaging Unit generates strong magnetic force. Do not bring it near a
cathode-ray tube or watch.
•
The lithium cell in RAM Board PWB-R can burst. At replacement, make sure of the correct polarity
and do not change it or create a closed circuit.
A used lithium cell should be disposed of according to the local regulations and never be
discarded casually or left unattended at the user's premises.
•
Do not use an air gun or vacuum cleaner for cleaning the ATDC Sensor and other sensors, as
they can cause electrostatic destruction. Use a blower brush and cloth. If a unit containing these
sensors is to be cleaned, first remove the sensors from the unit.
•
When handling the PWBs with MOS ICs, observe "1-2. Instructions for Handling the PWBs with
MOS ICs."
•
When handling the PC Drum, observe precautions given in "1-3. Handling of the PC Drum."
•
Note that replacement of a PWB may call for readjustments or resetting of particular items.
•
Use the right screw in the right place at reassembly. Note that some are longer and some are
thicker than others.
•
A toothed washer is used with the screw that secures the ground wire to ensure positive
conduction. Do not forget to insert this washer at reassembly.
•
To reassemble the copier, reverse the order of disassembly unless otherwise specified.
•
If it becomes necessary to replace the thermal fuse or any other fuse mounted on a board, be sure
to use one of the rating marked on the blown fuse.
Always note the rating marked on the fuse, as the rating and mounting site or number used are
subject to change without notice.
•
Do not pull out the Toner Hopper while the Toner Bottle is turning, as a damaged Toner
Replenishing Motor or locking mechanism could result.
If the copier is to be run with the Front Door swung down, make sure that the Toner Hopper is in
the locked position.
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE
ONLY WITH THE SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER.
DISCARD USED BATTERIES ACCORDING TO THE MANUFACTURER'S INSTRUCTIONS.
D-1