Replacement Of The Lamp - Leica CM1900 Instruction Manual

13.2 Replacement of the lamp

1
2
Leica CM1900 – Cryostat
3
4
Turn the instrument off with the mains switch
and pull the mains plug before replacing the
lamp!
• Slightly lift the sliding window (1) holding it by the
grip (2) and pull it out to the front.
If the lamp is broken, it must be replaced by
the technical service, as the replacement in-
volves a high risk of injury!
Removal of the lamp
• The lamp is mounted behind a glare shield and
therefore not visible.
• Touch the lamp for better orientation.
• Lightly tilt the flourescent tube down to the left and
pull it out of the clip (3).
• Hold the lamp with both hands and pull it to the left
out of the holder (4).
Only use lamps of the same specification!
Installation of the new lamp
Type:
(230 V / 50 Hz)
(120 V / 60 Hz)
• Hold the lamp in the correct mounting position as
shown and push it to the right until it engages in the
holder.
• Replace the sliding window.
• Reconnect the instrument to the mains power and
turn it on.
13. Maintenance
OSRAM DULUX S - 11 W
OSRAM DULUX S - 13 W
41