Bionaire BWM401 Instruction Leaflet

BWM401LA05307ESM1.qxd:BWM401LA05307ESM2.qxd 4/5/07 4:44 PM Page 1
HUMIDIFIER SAFETY
Warm Mist Humidifier
PLEASE READ AND SAVE
THESE IMPORTANT
MODEL
BWM401
SAFEGUARDS
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance
directly into an outlet of the same voltage as the one
indicated on the rating plate of your appliance.
3. Keep the cord out of heavy traffic areas. To avoid fire
hazard, NEVER put the cord under rugs or near heat
registers.
4. DO NOT place humidifier near heat sources such as
stoves, radiators, and heaters. Locate your humidifier
on an inside wall near an electrical outlet. The
humidifier should be at least 4" away from the wall for
best results.
5. NEVER place humidifier in an area where it is
accessible to children. NEVER use humidifier in a
closed room, particularly where a child may be
sleeping, resting, or playing (a closed room may result
in excessive humidity).
6. WARNING: Do not attempt to refill humidifier without
first unplugging the unit from its electrical outlet.
Failure to heed this warning may cause personal
injury. Be sure to unplug the unit by pulling on the
plug and not the cord.
7. Never place anything over moisture outlet when the
unit is running.
8. NEVER drop or insert any object into any openings.
9. DO NOT operate any appliance with a damaged cord
or plug, after the appliance malfunctions, or if it has
been dropped or damaged in any manner. Return
appliance to manufacturer for examination, electrical
or mechanical adjustment, or repair.
10.Use appliance only for intended household use as
Read instructions before operating.
described in this manual. Any other use not
Retain for future reference.
recommended by the manufacturer may cause fire,
Instruction Leaflet
electric shock, or injury to persons. The use of
attachments not recommended or sold by the
manufacturer may cause hazards.
11.DO NOT use outdoors.
12.Always place humidifier on a firm, flat, level surface. A
waterproof mat or pad is recommended for use under
AUTO SAFETY SHUT OFF
Troubleshooting
This humidifier is equipped with a technologically
Trouble Probable Cause Solution
advanced, safety system that requires the user to reset
the humidifier if there is a potential overheat situation.
• Water leaks * Remove tank cap
Tank rubber ring is
When a potential overheat temperature is reached, the
from tank. missing. and replace or
system will automatically shut the humidifier off. It can
reposition ring.
only resume operation when the user resets the unit.
* Cap not tight Tighten the cap.
enough. To reset the humidifier
* Tank water is hot. Fill with cool water only.
1. Unplug unit, wait 15 minutes.
• Crack in tank.
* Hot water will cause Fill with cool water only.
2. Press the reset button on the bottom of the unit.
tank to pressurize.
* Tanks will crack if hit Handle tank with care. HOW YOUR WARM MIST HUMIDIFIER WORKS
or dropped.
Your Bionaire
• Film on tank. * Mineral deposits. Clean/disinfect tank
the proper amount of water to flow out of the tank and
as instructed in weekly
into the Heating Chamber where the Electronic Thermal
cleaning instructions.
Control Heating Element warms the water. Air is drawn in
through the grill openings located in the back of the unit
and mixed with steam in the misting chamber. The warm
Frequently Asked Questions
mist is then dispersed out of the top of the misting
chamber through the outlet grill and into the room.
Question Answer
NOTE: A humidity level below 20% can be unhealthy and
• What are the The estimated run time for this humidifier is
uncomfortable. The recommended humidity level is
variables that affect based on average room conditions. The actual
run time? run time of your humidifier is dependent on between 40%-50%.
numerous variables such as:
CLEANING AND MAINTENANCE INSTRUCTIONS
Air exchange in the room where the
humidifier is placed.
Humidifiers provide comfort by adding moisture to dry,
Room construction of the room where the heated indoor air. To benefit most from the humidifier and
humidifier is placed.
avoid product misuse, follow all instructions carefully.
Temperature of the room where the Please note that this is an electrical appliance and
humidifier is placed.
requires attention when in use.
Humidity levels in the room where the
In addition, if you do not follow the recommended care
humidifier is placed.
and maintenance guidelines, micro-organisms may be
Movement of occupants and the opening
able to grow in the water within the humidifier's tank and
and closing of doors in the room where the
become airbone. You must routinely follow the cleaning
humidifier is placed.
and maintenance procedures in order to ensure proper,
Home furnishings in the room where the
efficient operation of your humidifier. Proper maintenance
humidifier is placed.
and cleaning is essential to the continued performance of
• How do I remove film See Daily Maintenance instructions.
your unit and the avoidance of algae or bacteria build-up.
on water tank? Regular cleaning is recommended.
DAILY MAINTENANCE
Run your unit on the lowest setting.
• How can I extend
the run time? 1. Be sure the unit is OFF by pressing the power button
If your unit has electronics, set it to your
desired humidity level. The unit will turn on so that the power light no longer illuminates. Unplug
and off, which will extend the run time.
the unit from the electrical outlet.
Fill the tank all the way full, place it on the
2. Remove the tank from the humidifier and carefully
base, let the water empty into the base until
bring to a sink or tub. Hold the base of unit level as
it stops bubbling, then refill the tank full
you carry it to prevent excess water from sloshing or
again. This ensures maximum water
spilling.
capacity and will extend run time.
3. Drain or sponge up any remaining water and rinse
thoroughly to remove any sediment or dirt. Wipe
clean and dry with a clean cloth or paper towel.
4. Refill with cool tap water. Do not overfill.
the humidifier. NEVER place it on a rug or carpet, or
on a finished floor that may be damaged by exposure
to water or moisture.
13.DO NOT allow the Moisture Outlet to directly face the
wall. Moisture could cause damage, particularly to
wallpaper.
14.Humidifier should be unplugged when not in use.
15.NEVER tilt, move, or attempt to empty unit while it is
operating. Shut off and unplug before removing the
water tank and moving the unit.
16.This humidifier requires daily and weekly maintenance
to operate appropriately. Refer to daily and weekly
cleaning procedures. Use only cleaners and additives
recommended by the manufacturer.
17.NEVER use detergents, gasoline, glass cleaner,
furniture polish, and paint thinner, or other household
solvents to clean any part of the humidifier.
18.Excessive humidity in a room can cause water
condensation on windows and some furniture. If this
happens, turn the humidifier OFF.
19.DO NOT use humidifier in an area where humidity
level is in excess of 50%. Use a hygrometer, available
at your local retailer or through the manufacturer, to
measure the humidity.
20.DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed
by qualified personnel only.
21.NEVER place housing under water flow or immerse in
liquids.
22.DO NOT plug in the cord with wet hands: electric
shock could result.
23.DO NOT pour water in any openings other than the
water tank.
24.To prevent damage to surfaces, do not place
humidifier under overhanging surfaces.
25.NEVER operate unit without water in the tank.
26.DO NOT move unit while it is operating.
27.Use both hands when carrying full tank of water.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
CONSUMER SAFETY INFORMATION
NOTE: This is an electrical appliance and requires
attention when in use.
WEEKLY MAINTENANCE
To Remove Scale
1. Repeat steps 1-3 under Daily Maintenance section.
2. Clean all surfaces with a soft brush. Gently scrub the
heating element and the area around it with a soft
brush. Remove the scale by wiping the entire base
with a cloth dampened with undiluted white vinegar.
3. Rinse clean with warm water to remove cleaning
solution before disinfecting the tank.
To Disinfect Tank
1. Fill tank with 1 teaspoon of bleach and 3.5 litres of
® Warm Mist Humidifier is designed to allow water.
2. Let the solution stand for 20 minutes, shaking every
few minutes. Wet all surfaces.
3. Empty the tank after 20 minutes, and rinse well with
water until the bleach smell is gone. Leave to dry.
4. Refill the water tank with cool water; replace the water
tank. Repeat Operating Instructions.
NOTE: If moisture forms on the walls or windows of the OPERATING INSTRUCTIONS (SEE FIG.1 - 2)
room, turn off the humidifier. The room already has plenty
Your Humidifier is equipped with a technologically
of humidity and additional moisture may cause damage.
advanced AccuSet
NOTE: DO NOT block air inlet or outlet. Humidifier to run continuously in manual mode or set the
AccuSet TM Digital Humidistat to your desired humidity
CONSUMER SAFETY INFORMATION
setting. The AccuSet
This appliance has a polarized plug (one
automatically turn the humidifier ON or OFF, depending
blade is wider than the other). To reduce
on the preset comfort level. The comfort level ranges
the risk of electric shock, this plug is
from 35% to 65% relative humidity.
intended to fit in a polarized outlet only
one way. If the plug does not fit fully in
MANUAL MODE
the outlet, reverse the plug. If it still does
NOTE: After starting the unit from cold, it will take 5–10
not fit, contact a qualified electrician to
minutes before any noticeable steam is emitted from the
install the proper outlet.
Outlet Grill.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR
1. When plugged in, the Display will show the current
DEFEAT THIS SAFETY FEATURE IN ANY WAY.
room humidity.
The length of cord used on this appliance was selected
2. To start the unit, press the MODE/OFF Button for the
to reduce the hazards of becoming tangled in, or tripping
HIGH (HI) manual setting.
over a longer cord. If a longer cord is necessary, an
3. Press the Button again for the LOW (LO) manual setting.
approved extension cord may be used. The electrical
rating of the extension cord must be equal to or greater 4. To stop the unit, keep pressing the Button until the
than the rating of the humidifier.
Display reads OFF (OF).
Care must be taken to arrange the extension cord so that
TM
ACCUSET
it will not drape over the countertop or tabletop where it
can be pulled on by children or accidentally tripped over. To take advantage of the AccuSet
1. Press the MODE/OFF button until you reach AU
SETUP INSTRUCTIONS
(Automatic) AccuSet
1. Select a location for your humidifier, on a flat, level
2. Adjust the set humidity by using the Humidity Set
surface about 4" away from the wall. DO NOT place
Button. The Display will show a setting in the range
the humidifier on a finished floor or near furniture,
35% – 65% and the humidity can be
which can be damaged by too much moisture or
increased/decreased in increments of 5%. When the
water. Place on a moisture-resistant surface.
room humidity level rises above the set humidity, the
2. Remove the tank from the base of the Humidifier.
Humidifier will stop. When the humidity level drops
3. Bring the tank to the sink, turn upside down and twist
below the set humidity, the Humidifier will turn on
off the tank cap by turning counter clockwise. Fill tank
automatically.
with cool, fresh tap water. DO NOT fill with warm
NOTE: The AccuSet
water as this may cause leaking. Replace the cap on
means that when you turn the unit back on to AccuSet
tank FIRMLY.
mode, it will remain at the setting the Humidifier was
4. Carefully bring the filled tank over to the humidifier,
previously set at, unless the unit has been unplugged.
holding it level to avoid sloshing or spilling of water.
REFILL PROCEDURE
5. Carefully place tank back onto the base to prevent
NOTE: When the Water Tank is empty and the water in
water from spilling. The tank will immediately begin to
the Heating Chamber is almost empty, the Red REFILL
flow into the base.
light will illuminate, the panel will display "FILL" and the
6. Plug the humidifier onto an outlet of the same voltage
Automatic Shut Off will activate.
as the one indicated on the rating plate of your
The unit will not operate again until you refill the Water
appliance.
Tank and reset the Humidifier as follows.
1. Remove and refill the Water Tank, being sure to follow
the Maintenance Instructions. Replace the Tank onto
the Base.
2. After 5 minutes, turn the unit on. The REFILL light
should now be off (if not repeat steps 1 through to 2).
In about 5 minutes, the Humidifier will begin to
produce moisture.
STORAGE INSTRUCTIONS
When not using your humidifier for an extended period of
time:
1. Clean, rinse and thoroughly dry the humidifier as
directed in weekly maintenance. DO NOT leave any
water in the unit when storing. Leaving water in the
unit may render the unit inoperable for the next
season.
2. Place the humidifier in its original carton and store in a
cool, dry place.
SERVICE INSTRUCTIONS
Do NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void the
warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed by
qualified personnel only.
© 2007 Sunbeam Products, Inc. doing business as Jarden
Consumer Solutions. All Rights Reserved. Distributed by
Sunbeam Latin America, LLC, 5200 Blue Lagoon Drive,
Suite 470, Miami, Florida 33126.
Printed in China
3. If you do not plan to use the Humidifier for two or
more days, make sure any residual water is drained
from the Water Tank and Base to prevent algae or
TM Digital Humidistat. You can set the
bacteria growth.
TM Digital Humidistat will
Fig. 1
C
A
E
HUMIDISTAT MODE
TM Digital Humidistat:
TM . G
A. Lid
B. Medication cup
C. Moisture Outlet
D. Handle
TM Humidifier has memory. This
E. Water Tank
TM
Fig. 2
K
M
J. Display Lens
K. Humidity Set Button
L. Mode/Off Button
M. Refill Light
N. Power Light
B
D
F
E
A
H
I
F. Air Inlet (Not Shown)
G. Control Panel
H. Base
I. Misting Chamber
J
L
N