INTRODUCTION Thank you for purchasing this CLARKE Sand Blast Cabinet which is designed for professional workshop use. Before attempting to operate the cabinet, please read this manual thoroughly and carefully follow all instructions given. In doing so you will ensure the safety of yourself and that of others around you, and you can also look forward to the product giving you long and satisfactory service.
DESCRIPTION The cabinet is lit by a low voltage (12 volt) fluorescent tube, fed from a plug-in type transformer. The switchbox is mounted on the left side of the cabinet. The transformer should be plugged directly into the mains supply and connected to the switchbox which contains the ON/OFF rocker switch.
Page 4
INVENTORY Carefully unpack the unit, and check to ensure that no damage was caused in transit. Should any damage be apparent, please contact your Clarke dealer immediately. Remove all components from the carton and check them against the following. ITEMS SUPPLIED LOOSE.
Page 5
ASSEMBLY NOTE: PTFE tape is provided for use to ensure an airtight fit. 1. Lay the cabinet on its back and attach the four legs using the M6 x12mm screws, flat washers and nuts, ensuring the flat washers are against the screw heads. 2.
OPERATION Plug the transformer into the power supply and switch the power ON. Switch the lamp ON by pushing the rocker switch on the switch box ‘I’. Switch OFF by pushing ‘O’. Ensure all air connections are secure, and the pick up is correctly located beneath the grid, before filling the cabinet with abrasive media.
Change the window protective film should visibility be impaired. Simply peal off the old film and replace with a new one. Replacement protection film is available from your Clarke dealer. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Page 8
Ensure you comply with all precautions regarding the use of compressed air, and air compressor operation. Inspect the abrasive media regularly. If badly contaminated, it should be replaced. A hinged cover is provided at the base of the funnel to allow quick draining of the media.
TROUBLESHOOTING Problem Check Solution Excessive dust in the No dust extract device Install dust extract cabinet. used. device. Air vent or overflow Clean rear vent and blocked. keep vent away from any wall. Abrasive media worn. Replace abrasive media Too much abrasive media in Remove excessive the cabinet.
PARTS LIST PART NO DESCRIPTION PART NO DESCRIPTION Cabinet Air Adaptor Nut Intake Guard Ring Low Voltage Light Intake Vent Cover Light Clamp Hinge Steel Screen Plastic Door Cotton Sealant Metal Liner Cabinet Duct Gloves (pair) Abrasive Suction Pipe Clamp for Glove Abrasive Removal Cover Glove mounting ring Cover Lock...