Table of Contents
Advertisement
U.S. Stove Pellet Burning Room Heaters are also available as an insert into existing masonry of factory‐built
fireplaces. Do not alter the existing fireplace in any way either by removing bricks and mortar which could
weaken the structural integrity of the fireplace. There is a small amount of assembly required when installing
this model. The steps are as follows:
Note: The shroud must be installed before unit is set into its final position.
Step 1: Shroud Side: Facing the back of the unit take the left shroud side piece (no control panel hole) and fasten, as
shown, with 2 screws provided.
Step 2: Shroud Side: Facing the back of the unit take the right shroud side piece (with control panel hole) and fasten, as
shown, with 2 screws provided.
INSERT PELLET STOVE INSTALLATION
25
Hide quick links:
Advertisement
Table of Contents
