Thermostat Installation - United States Stove PELLET 5660(I) Installation And Operating Manual

Optional thermostats are available for use with your pellet stove. A thermostat can help you maintain a constant
room temperature. The thermostat option will require the installation of a millivolt type thermostat.
NOTE: Your thermostat should be installed by an authorized dealer or service person.
Installation of Remote Thermostat:
 Disconnect Pellet Stove Room Heater unit from power supply.
 Open right side panel to gain access to rear of control panel.
 Strip insulation from thermostat wires and connect to the screw terminal on the rear of the control panel (see
Figure 4).
If you have installed a remote thermostat for your pellet stove and wish to have the heater controlled by that
thermostat, depress the MODE button to engage T‐STAT mode. The thermostat will control the heat output of the
heater alternating between the lowest heat level and the highest heat level that you have pre‐selected.
The T‐STAT mode provides the most even heat output, for better comfort, and to extend the life of the pellet fuel
ignition system. Additionally, the constant flame serves as a warning for people and pets to keep away from the
heater while it is in operation.
THERMOSTAT INSTALLATION
Left: GND
Middle: Thermostat
Right: 5V power source
12