Table of Contents
Advertisement
Owner's Instruction and Operation Manual
Model Number:
KP130
Report Number: F20-570
Certified to ASTM E1509-12 (2017)
and ULC-S627-00-REV1
Mobile Home Approved
* All Pictures In This Manual Are For Illustrative Purposes Only. Actual Product May Vary.
Save These Instructions In A Safe Place For Future Reference.
SAFETY NOTICE: If this heater is not properly installed, a house fire may result. For
your safety, follow the installation instructions. Never use make-shift compromises
during the installation of this heater. Contact local building or fire officials about
permits, restrictions and installation requirements in your area. NEVER OPERATE
THIS PRODUCT WHILE UNATTENDED.
CAUTION! Please read this entire manual before you install or use your new room
heater. Failure to follow instructions may result in property damage, bodily injury, or
even death. Improper Installation Will Void Your Warranty!
U.S. Environmental Protection Agency
Certified to comply with 2020 particulate
emissions standards.
THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE.
© 2021 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380
R
CALIFORNIA PROPOSITION 65 WARNING:
This product can expose you to chemicals including carbon
monoxide, which is known to the State of California to cause
cancer, birth defects, and/or other reproductive harm. For
more information, go to
853143B-0403K
www.P65warnings.ca.gov
Ph. 800-750-2723
Advertisement
Table of Contents
Related Manuals for United States Stove KP130
Summary of Contents for United States Stove KP130
- Page 1 State of California to cause cancer, birth defects, and/or other reproductive harm. For emissions standards. more information, go to www.P65warnings.ca.gov THIS MANUAL IS SUBJECT TO CHANGE WITHOUT NOTICE. © 2021 United States Stove Company, 227 Industrial Park Rd., South Pittsburg, TN 37380 Ph. 800-750-2723...
- Page 2 Your pellet stove has been safety tested and listed to ASTM E1509-12 (2017) and ULC-S627-00. This manual describes the installation and operation of the King, KP130 pellet stove. This heater meets the 2020 U.S. Environmental Protection Agency’s crib wood emission limits for wood-heaters sold after May 15, 2020. Under specific EPA test conditions burning wood pellet fuel this heater has been shown to deliver heat at a rate of 8,932 to 25,701 Btu/hr.
-
Page 3: Installation Checklist
Declaration of Completion: As the qualified person responsible for the work described above, I confirm that the appliance as associated work has been installed as per manufacturer’s instructions and following any applicable building and installation codes. Signed: ______________________________________ Print Name: __________________________________Date: ______________ Home Owner: RETAIN THIS INFORMATION FOR FUTURE REFERENCE © 2021 United States Stove Company... -
Page 4: Installation
CORD IN FOOT TRAFFIC AREAS OR PINCH THE CORD UNDER FURNITURE. US Stove highly recommends your stove be installed by a qualified NFI (US) or WETT (Canada) technician. To find the nearest qualified installer, go to: https://nficertified.org, https://www.wettinc.ca/ © 2021 United States Stove Company... -
Page 5: Installation Options
H Adjacent wall to unit 8” 203 mm CLEARANCES ALCOVE J Alcove depth 36” 914 mm Your pellet stove has been tested and listed for installation in residential, mobile home, and alcove applications in © 2021 United States Stove Company... -
Page 6: Outside Air Supply
The maximum recommend vertical venting height is 12- the floor of the home. feet for 3-inch type “PL” vent. Total length of horizontal © 2021 United States Stove Company... -
Page 7: Pellet Vent Termination
Vent surfaces can get hot enough E. Minimum 2-foot (0.61m) clearance above any grass, to cause burns if touched by children. Noncombustible plants, or other combustible materials. shielding or guards may be required. © 2021 United States Stove Company... - Page 8 4 inch “PL” pellet venting products. The use of other of vertical venting. An approved vertical vent cap is components other than stated herein could cause bodily recommended. harm, heater damage, and void your warranty. © 2021 United States Stove Company...
-
Page 9: Through The Wall Installation
If clearance through a combustible wall. Once outside the an offset is required, it is better to install 45-degree structure, a 3” (76 mm) clearance should be maintained elbows rather than 90-degree elbows. © 2021 United States Stove Company... -
Page 10: How Your Stove Works
If this situation continues, the fuel in the burn pot © 2021 United States Stove Company... -
Page 11: Control Panel Overview
See the list of button is pressed. The fan will automatically adjust its error codes found at the end of this manual. speed in accordance to the heat range setting. However, © 2021 United States Stove Company... -
Page 12: Thermostat Hook-Up
T’Stat requires more heat, the unit will begin to feed pellets at the preselected heat setting ranging from “1” to “5”. Use 18 gauge, 2 conductor wire © 2021 United States Stove Company... -
Page 13: Proper Fuel
INTO AN ELECTRICAL OUTLET. THESE MOVING PARTS MAY BEGIN TO MOVE AT ANY TIME Your pellet stove is designed to burn premium hardwood WHILE THE STOVE IS PLUGGED IN. pellets that comply with the Pellet Fuels Institute (PFI) © 2021 United States Stove Company... - Page 14 If the door is opened while the stove is in operation it must be closed within 30 seconds or the stove will shut © 2021 United States Stove Company...
- Page 15 The clean outs are secured to the firebox with (2) 5/16” screws each. Remove the clean outs and vacuum out any accumulated ash. This should © 2021 United States Stove Company...
-
Page 16: Maintenance
CO. the top as well as from the bottom. The creosote should be removed with a brush specifically designed for the © 2021 United States Stove Company... -
Page 17: Spring Shutdown
Gaskets Inspected 5. Re-install the retainer and eight nuts and rope gasket Glass Wiped Cleaned using high-temperature silicone to adhere the gasket Hopper (end of Empty & to the door. season) Vacuumed © 2021 United States Stove Company... -
Page 18: Troubleshooting Guide
ATTENTION: THIS WOOD HEATER NEEDS PERIODIC INSPECTION AND REPAIR FOR PROPER OPERATION. IT IS AGAINST FEDERAL REGULATIONS TO OPERATE THIS WOOD HEATER IN A MANNER INCONSISTENT WITH OPERATING INSTRUCTIONS IN THIS MANUAL. © 2021 United States Stove Company... -
Page 19: Display Indicators
FACTORY DEFAULTS To return the control to its original factory default settings, press and hold the AUX UP and AUX DOWN buttons together for three seconds. © 2021 United States Stove Company... -
Page 20: Repair Parts
REPAIR PARTS © 2021 United States Stove Company... -
Page 21: Wiring Diagram
Part numbers and descriptions can be found in the “Repair Parts” section of this manual. Once this information has been gathered you can contact customer service by phone 1-800-750-2723 Ext 5051 or Email parts@usstove.com. Model Information Model Number Serial Number © 2021 United States Stove Company... -
Page 22: Service Record
Engineer Name: ____________________________________ Engineer Name: ____________________________________ License No.: ________________________________________ License No.: ________________________________________ Company: __________________________________________ Company: __________________________________________ Telephone No.: _____________________________________ Telephone No.: _____________________________________ Stove Inspected: Chimney Swept: Stove Inspected: Chimney Swept: Items Replaced: ____________________________________ Items Replaced: ____________________________________ © 2021 United States Stove Company... - Page 23 NOTES © 2021 United States Stove Company...
- Page 24 NOTES © 2021 United States Stove Company...
- Page 25 NOTES © 2021 United States Stove Company...