Installing Your Room Heater - United States Stove PELLET 5660(I) Installation And Operating Manual

INSTALLING YOUR ROOM HEATER
You have already made the important decision of choosing your U.S. Stove Pellet Burning Room Heater;
now your next step is to determine where to install your new pellet stove heater. To get the most
efficient use of re‐circulated heat, you should consider a room that is centrally located within your home.
Choose a room that is large and open.
It is Extremely Important to maintain proper clearances from any combustible surfaces or materials in
the room where your heater will be located. You can find proper clearance measurements on page 13 of
this manual and on the rating label of your pellet stove.
The pellet stove can be vented through an exterior wall or into an existing masonry or metal chimney.
The chimney must be lined if it is over 6" (150mm) in diameter or if it has a cross‐sectional area of over
2
28 square inches (711mm ). Venting can pass through the ceiling and roof if approved pipe is used.
Where passage through a wall, or partition of combustible construction is desired, the installation must
conform to CAN/CSA‐B365
DO NOT OBTAIN COMBUSTION AIR FROM THE ATTIC, GARAGE OR ANY OTHER UNVENTILATED AREA.
YOU MAY OBTAIN COMBUSTION AIR FROM A VENTILATED CRAWLSPACE.
DO NOT INSTALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT.
DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER HEATER, FURNACE OR
APPLIANCE.
INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER.
ONLY USE APPROVED MATERIAL FOR INSTALLATION, FAILURE TO DO SO MAY RESULT IN PROPERTY
DAMAGE, BODILY INJURY, OR EVEN DEATH.
This appliance is certified for use with listed 3 inch or 4 inch "PL" or "L" pellet venting products as well as
Selkirk's Direct‐Temp Vent system for pellet burning appliances. The use of other components other
than stated herein could cause bodily harm, heater damage, and void your warranty.
14