Using Accessories - Bosch OptiMUM MUMPCV4S12 Instruction Manual

en

Using accessories

Pre-setting the weight
X Image sequence L
1. Press button C and don't touch the
appliance again.
Individual dashes appear one after each
other on the display during calibration:
"– – – – –" (tare).
2. "0 g" or "0 lb" appears on the display
(depending on the setting). The scales
are ready.
3. "100 g" or "0.20 lb" appears on the
display (depending on the setting).
4. Set the required weight (50-3000 g /
0.10-6.00 lb) using the + or - button.
5. Add ingredients. The quantity still
missing is shown on the display, e.g.
"65 g".
6. From "40 g", a recurring acoustic signal
sounds. The lower the remaining
quantity, the faster the acoustic signal
sounds.
Note: Setting the acoustic signal
X "Settings" see page 26
7. At "0 g" (meaning that the pre-set
quantity has been added), the acoustic
signal stops.
8. If the pre-set quantity has been
exceeded, the acoustic signal will sound
continuously.
Note: Setting the acoustic signal
X "Settings" see page 26
The additional weight is indicated
with a minus symbol. If the quantity is
exceeded by 25 g, "–25 g" is displayed.
■ Either remove the excess quantity
added or hold down one of the function
buttons (D/A/C) until "OptiMUM"
appears on the display.
32
Using accessories
Your kitchen machine offers a number
of accessories that significantly extend
its functions. Depending on the model,
certain accessories are already included
in the scope of supply. If an accessory
is not included, it can be purchased
via trade stockists or customer service.
X "Accessories" see page 38
Preparation for accessories
The base unit requires different preparation
depending on the accessory.
■ Place the base unit on a smooth, clean
and stable surface.
■ Pull the power cord out to the required
length.
■ Prepare the base unit as shown
depending on the accessory.
X Fig. M
1. Preparation for tools.
2. Preparation for accessories on black
drive with bevel gear and accessory
used in place of the bowl.
3. Preparation for accessory on red drive,
for example blender or multi-chopper.
4. Preparation for accessory on yellow
drive without outlet opening for food,
e.g. multi-blender or citrus press.
5. Preparation for accessory on yellow
drive with outlet opening for food, e.g.
continuous-feed shredder.
Important:
■ Observe yellow, red or black marking on
drive and accessory. X "Colour coding"
see page 24
■ Always secure unused drives with
protective drive covers.
■ See the separate instructions for the
individual accessory for all further steps.