Using Sensorcontrol Plus - Bosch OptiMUM MUMPCV4S12 Instruction Manual

7. Once the remaining duration has
elapsed, an acoustic signal will sound
and the appliance will stop processing
automatically. "FINISH TIMER" appears on
the display.
Note: Setting the acoustic signal
X "Settings" see page 26
8. „TURN ROTARY SWITCH TO 0" appears on
the display.
9. Turn the rotary switch to y.
"OptiMUM" appears on the display.
10. Disconnect the mains plug.
11. Processing with the "TIMER" function is
ended.
12. Clean all parts immediately after use.
X "Cleaning and maintenance" see
page 33
Notes:
– The duration is indicated on the display
in minutes and seconds. Example:
1 minute and 30 seconds: "01:30". If the
duration is 60 minutes or more, hours
are also displayed: "1:01:30".
– Press button + or - at any time to adjust
the displayed remaining duration.
– Press button A briefly twice to stop the
timer (the appliance will continue to run) or
to start it again.
– Turn the rotary switch to E to interrupt
processing. The remaining duration
remains saved and the countdown will
continue after the appliance is switched on
again.
– Hold down button A to switch the timer off.
"00:00" appears on the display. The "TIME"
function has been activated again.
Using the timer without processing food:
■ Press button A. "00:00" appears on the
display.
■ Set the required processing duration using
button + or -.
■ Press button A briefly twice to start the
timer.
■ The remaining duration will be shown
on the display and the countdown will
continue.

Using SensorControl Plus

■ Once the duration has elapsed, an acoustic
signal sounds. "FINISH TIMER" appears on
the display.
Notes:
– Press button A briefly twice to stop the
timer or to start it again.
– If food starts to be processed while
using the timer, the appliance will
continue to run until the remaining
duration has elapsed and then stop
processing automatically.
Using SensorControl Plus
Depending on the model, the appliance
may be equipped with SensorControl Plus
automatic programmes. Sensors monitor
the processing of the ingredients and switch
the appliance off once the pre-programmed
consistency has been reached.
The following automatic programmes are
available with SensorControl Plus:
– CREAM
Automatic preparation of whipped cream
– EGG WHITE
Automatic preparation of (beaten)
egg white
– YEAST DOUGH
Automatic preparation of yeast dough.
Selecting programme
■ Press button D. "CREAM" appears on
the display.
■ Press button D or buttons +/-.
The following programmes appear in
sequence:
Programme Tool/Ingredients
Professional stirring whisk
CREAM
> 300 ml * 300-700 ml cream
Professional stirring whisk
CREAM
> 700 ml * 700-1500 ml cream
EGG WHITE Professional stirring whisk
White of 2-12 eggs
Kneading hook
YEAST
Ingredients and quantities
DOUGH
according to the recipe
X "Recipes" see page 33
en
29