Table of Contents
Advertisement
en
Preparation
Bowl and cover
X Fig. D
The appliance comes with a special bowl,
which is securely attached to the base unit
through insertion and rotation. The cover
is secured to the swivel arm and opens
automatically when the swivel arm is raised.
Inserting and removing tools
X Fig. E
The tools are equipped with eject buttons
on the protective cap which are used to
facilitate removal of the tools.
Insert tool: Insert the tool into the main
drive until it locks into place. The drive is
then covered by the protective cap.
Remove tool: Press both eject buttons
until the tool is released. Take the tool out
of the drive.
Cable reel
X Fig. A
Depending on the model: The
appliance is equipped with an automatic
cable reel. Pull out the power cord in one
go to the required length (max. 125 cm) and
slowly release; the cord is locked.
Reduce cable length: Pull gently on the
cord and allow it to wind up to the required
length. Then gently pull the cord again and
slowly release; the cord is locked.
Important: Do not push the cord in by
hand. If the cord jams, pull out the cord all
the way and then allow it to wind up again.
Cable storage
compartment
X Fig. A
Depending on the model: The appliance
is equipped with a cable storage
compartment. The length of the power cord
can be adjusted as required by pulling it out
or pushing it back.
Safety systems
The appliance has various safety systems.
X "Safety systems" see page 35
26
Preparation
■ Place the base unit on a smooth, clean
and stable surface.
■ Pull the power cord out to the required
length.
■ Press the release button and raise
the swivel arm to the stop.
■ Place the cover with the filling shaft at
the front on the main drive.
■ Insert the bowl. When doing so, use the
recesses on the base unit.
■ Turn the bowl anticlockwise until it locks
into place.
The base unit is prepared for further use.
Important: Do not slide the appliance about
on the work surface as this may impair
the functioning of the scales. To move the
appliance, lift it.
Settings
■ Press the release button and push the
swivel arm down until it locks into place.
■ Plug the mains plug into the mains.
The appliance is switched on.
■ "OptiMUM" appears on the display.
Note: If the appliance is not used or
operated within a certain period, the display
will slowly fade and switch to standby
mode. "OptiMUM" will appear once again
when any button is touched.
■ Press and hold buttons A and + at the
same time until the configuration menu
is opened.
■ Release buttons A and + again.
Selecting setting
■ The following settings appear in
sequence each time button A is briefly
pressed:
– LANGUAGE
Language in which the display texts are
displayed.
– SOUND
Volume of the acoustic signals – setting
in 6 levels from off to loud.
– BRIGHTNESS
Brightness of the display – setting in
6 levels from dark to bright.
Advertisement
Chapters
Table of Contents
