How To Use This Guide; Checking The Gas Analyzer; The Gas Analyzer; The Front Panel - ADInstruments ML206 Owner's Manual

Figure 1–1
Front panel of the
Gas Analyzer
14

How to Use This Guide

Th is owner's guide describes how to set up and begin using your Gas
Analyzer. Topics discussed included how to connect the hardware, perform
a simple power-up test and calibration of the Gas Analyzer. Th e appendices
provide technical information about the Gas Analyzer and look at some
potential problems and their solutions. Th ere is an index at the end of this
guide.

Checking the Gas Analyzer

Before connecting the Gas Analyzer to anything, check it carefully for signs
of physical damage.
1. Check that there are no obvious signs of damage to the outside of the
Gas Analyzer casing.
2. Check that there is no obvious sign of internal damage, such as
rattling. Pick up the Gas Analyzer, tilt it gently from side to side, and
listen for anything that appears to be loose.
If you have found a problem, contact your authorized ADInstruments
representative immediately, and describe the problem so arrangements can
be made to replace or repair the unit.

The Gas Analyzer

Th e remainder of this chapter contains general information about the
features, connections and indicators of the Gas Analyzer. More detailed
information can be found in Appendix A.

The Front Panel

Power Status Pump switch
indicator indicator and indicator
Gas sample inlet port Flow Control
Gas Analyzer Owner's Guide