Connecting To Power Supply - Stihl HSE 61 Instruction Manual

To extend your reach, hold the control
handle with one hand and operate the
auxiliary switch at the rear of the control
handle with the other hand.
HSE 61, HSE 71, HSE 81

Connecting to Power Supply

The voltage and frequency of the
machine (see rating plate) must match
the voltage and frequency of the power
connection.
The minimum fuse protection of the
power connection must comply with the
specifications – see "Specifications".
The machine must be connected to the
power supply via an earth-leakage
circuit breaker to disconnect the power
supply if the differential current to earth
exceeds 30 mA.
The power connection must correspond
to IEC 60364 and relevant national
regulations.
Extension cord
The design of the extension cord must at
least fulfill the same features as the
connecting cord on the machine.
Observe the design marking (type
designation) on the connecting cord.
The cores in the cord must have the
following minimum cross-section
depending on the mains voltage and
cord length.
Cord length Minimum cross-
section
220 V – 240 V:
Up to 20 m 1.5 mm
20 m to 50 m 2.5 mm
100 V – 127 V:
Up to 10 m AWG 14 / 2.0 mm
10 m to 30 m AWG 12 / 3.5 mm
Insert the plug (1) into the extension
N
cord coupling (2).
Strain Relief
The strain relief (cord retainer) protects
the connecting cord against damage.
2
2
2
2
English
1 2
29