3-5 PROCEDURE OF OUTGOING TEST
3-S·l Pre-Setting
a.
Connect the test drive to the ATP System. (Refer to
Fig. 2-2)
b.
Tum on the power of the computer.
Note:
Make
sure PC-DOS has been installed in the hard
disk of the computer.
c.
After system loading, insert the SLCD Test Disk into
drive A.
d.
Change directory in drive A.
e.
Type
l!ll!Jj9@]~~1!1~
and IEnterl key to start the test.
(Main menu will be displayed.)
f.
1/0 address setting
f-1.
Select the
~,D_R_l_V_E_&_l_/O_C_a_rd_S_E_L=ECT=j
in the
right column with arrow keys, then hit IEnterl key.
(1/0 card menu will be displayed.)
f-2.
Type@l@JIQI and IEnterl key.
g.
Open the tray by pressing the Eject button located on
the front panel ass'y.
h.
Put the YHDS-50 disc on the tray and then insert the
tray.
i.
Spin up mode setting
i-1.
SelectlSIH Spin uplin the right column with arrow
keys, then hit IEnterl key.
i-2.
Select IEXECI with arrow keys, then hit IEnterl key
to execute Spin Up. (Spin Up Menu will be
displayed.)
# # #
Exercizer program for SONY CD-ROM drive < SLCD > Ver X.XX
(C) 1991, 92 SONY
###
COMMAND
OOH ReQuest Drive Config
30H Read TOC
50H Eject
OlH ReQuest Drive Mode
31H Seek
51H Spin Up
02H ReQuest Drive Param.
32H Read
52H Spin Down
03H ReQuest Mecha. Status
33H
(Reserved)
04H ReQuest Audio Status
34H Read w /Blk Err. Status
60H Write Buffer
35H
(Reserved)
61H Read Buffer
lOH Set Drive Parameter
62H Diagnostics
40H Audio Playback
20H ReQuest TOC Data
41H Audio Stop
DRIVE STATUS (get REG)
21H ReQuest Subcode Addr
42H Audio Scan
DRIVE
&
1/0 card SELECT
22H ReQuest UPC/EAN
CHANGE TRANSFER/INTERRUPT
23H ReQuest ISRC
36H Read TOC
24H ReQuest TOC Data
(Reserved)
Any command
(Reserved)
(Reserved)
Message
Attention
!! !
code ( FF).
Attention
!!I
code ( FF ).
Attention
!!!
code ( FF ).
Attention
!!!
code ( FF").
Attention
!!I
code ( FF ).
< CURSOR > /ReQDrvCfg < AL T-V > /SpinUp < AL T-X > /ReadTOC <AL T-C >/Read <AL T-R > /ZoomM <AL T-Z >
Main Menu
3-11