Edit Test Condition; To Edit Any Test Conditions - Sony CDU31A Series Service Manual

3-3-3 Edit Test Condition
Note: Any editor can be used to edit any of the test conditions of the ATP SLCD. In this manual, the EDLIN editor is used to
edit test conditions.
I. Type
~@]ffiffi[!i:JO~[][BQ~[Qlf][Q]O~IYJ~
and hit !Enter! key. (Display 3-3-3 (a) shows up)
2. Type
[Qand
IEnted key. (Display 3-3-3 (b) (Specification list (S list)) shows up.)
End of input file
*
Display 3-3-3{a)
1 : ExeMode AUTO
2: diag on
3: Audio Test on
4:
5:
VO
Base Address (hex) 360
6: *IRQ channel 2
7: DRO channel
=
3
8:
9: SDwn /31A: 500
10: SUp /31A: 3000
11
~
12: Full 20
13: Fmax /31A: 1500
14: 1/3 20
15: Tave /31A: 850
16:
17: ASeek 31 A: 650
18:
19: EjTimeOut 20000
20: EJTm /31A: 1500
21:
22:
; AUTO or STEP
; diagnostics on or off
; base address (default : 360)
; IRO channel (default: 2)
; DRO, DACK channel (default : 3)
; 500 ms
; 3000 ms
=
3.0 sec
Count of full stroke (default : 20)
Count of 1 /3 stroke (default: 20)
Max 32000 ! Eject pressing Time-out (ms)
Display 3-3-3 (b)
3. To edit any test conditions.
a. To change address of 1/0 port. (default setting= 360)
ex. If it is 340 : (This address is set by dip switch. (Refer to Instruction Manual))
a-1.
Hit~
key in S list and hit !Enter! key.
The following will be displayed on the bottom of the screen.
5:
*VO
Base Address (hex)
=
360
5:*
a-2. Type 1/0 pon address as below and hit IEnted key.
5 :
*VO
Base Address (hex)
=
340
b. Other items are not necessary to change the specification.
3-4
; base address (default : 360)
; base address (default: 360)