Procedure Of Atp Test; Pre-Setting - Sony CDU31A Series Service Manual

3.3 PROCEDURE OF ATP TEST
3-3-1 Pre-setting
a. Connect the test drive to the ATP System. (Refer to
Fig. 2-2-2)
b. Tum on the power of the Computer.
Note: Make sure PC-DOS had been installed in the hard
disk of the computer.
(ATP _SLCD) Ver X.XX
xxxx xxxx xxxx
0 Disc Insert
1
Diagnostic
2
TOC Read Test
3 Spin Down Test
4 Spin Up Test
5-1 Full Seek Test ( /20)
5-2
1 /3 Seek Test
(
/20)
6 DMA Read Test
7-1 Disable Eject SW
7-2 Audio Test 1
7-3 Audio Test 2 (DI Ej.)
7-4 Audio Test 3 (DI Ej.)
8 Drawer Open (El Ej.)
IO_BASE ADDRESS: 360
CIRO : 2 DRO : 3 Not Used.)
EXE_MODE : AUTO
Eject Timeout : 20000 ms
Timer : DOS TIMER
-->
-->
-->
-->
-->
-->
-->
-->
-->
-->
-->
-->
-->
Hit any key to continue, Esc to abort.
SONY
c. After system loading, insen ATP SLCD DISK into
drive A.
d. Change directory in drive A.
e.
Type ~IT]~Q~[Qlf]!QI and !Enter! key. (After test
program loading, Display 3-3-1 (a) shows up.)
CD-ROM CDU31 A
Rev x.xh
judgement
Display 3-3-1(a)
3-2