Table of Contents
Advertisement
OPERATING MANUAL
INSTALLATION AND CONNECTION
Only use batteries of 12V voltage.
Before pluging N°4 to plug N°5 on the machine, connect the power cable N°8 to
the battery. Please follow :
1° Plug red pliers N°2 on the « + » terminal of the battery.
2° Plug black pliers N°3 on the « – » terminal of the battery.
3° Fit the power cable N°8 through support N°9.
4° Check that the switch N°10 on the is on « OFF », then plug N°4 to N°5 on the
machine.
OPERATING THE MACHINE
Switch « ON » N°10 to start up the machine. Before pluging in the power cable to
the plug N°5, check that the switch N°10 is on « OFF ».
You should stop work to recharge your battery as soon as a lack of power is thus
indicated.
This appliance needs to be used for around three days before optimal operation
and yield is achieved.
SAFETY PRECAUTIONS
Switch « ON » N°10 to start up the machine. Before pluging in the power cable to
the plug N°5, check that the switch N°10 is on « OFF ».
You should stop work to recharge your battery as soon as a lack of power is thus
indicated.
This appliance needs to be used for around three days before optimal operation
and yield is achieved.
We also recommend keeping the machine's protective tube, in case it
needs to be returned to the factory for after-sales service.
Whilst the appliance is in use, always keep the hands well away from the
vibration head.
1. 1. Always disconnect the ELECTRO'LIV from plug numbers 4 and 5 for all
operations other than harvesting, and
A BROKEN PRONG AS WELL AS DURING MANUAL HANDLING OF THE
RAKE.
2.
Make sure the rake is securely attached to the vibration head every
morning, To do so, disconnect at plug No.4.
MOST IMPORTANTLY WHEN REPLACING
8
Advertisement
Table of Contents
