Engine Oil Replacement; Cleaning And Adjusting Spark Plug - Sportsman GEN1000I-PL Instruction Manual

ENGINE OIL REPLACEMENT

1. Place the machine on a level surface and warm up the engine for several minutes. Then stop the engine and turn the
fuel cock knob to "OFF".
2. Loosen the screw and remove the cover.
3. Remove the oil filler cap
4. Place an oil pan under the engine.
Tilt the generator to drain the oil completely
5. Replace the generator on a level surface.
6. Add engine oil to the upper level.
7. Install the oil filler cap
8. Install the cover and tighten the screw
l Engine Oil SAE 10W30
l Be sure no foreign material enters the crankcase.
l Do not tilt the generator when adding engine oil. This could result in overfilling and damage to the engine
l Clean the oil filter every other 100 hr.
WASHABLE AIR FILTER
Maintaining an air cleaner in proper condition is very important. Dirt induced through
improperly installed, improperly serviced, or inadequate elements damages and wears out
engines. Keep the element always clean.
1. Remove the cover.
2. Remove the air filter cover and element.
3. Wash the element in solvent and dry.
4. Oil the element and squeeze out excess oil. The element should be wet but not dripping.
5. Insert the element into the air filter.
6. Install the cover.
The engine should never run without the Filter; excessive piston and/or cylinder wear may result.

CLEANING AND ADJUSTING SPARK PLUG

1. Remove the cover.
2. Check for discoloration and remove the carbon.
3. Check the spark plug type and gap.
CMR6A
Standard Spark Plug:
Spark Plug Gap: 0.6-0.7 mm (0.024-0.028 in)
Turn the fuel tank cap air vent knob clockwise.
Capacity: 7.5 oz.
11