Sportsman GEN1000I-PL Instruction Manual

Sportsman GEN1000I-PL Instruction Manual

Inverter generator

Advertisement

Item # GEN1000I-PL
1,000 MAX WATTS INVERTER GENERATOR
INSTRUCTION MANUAL
R E A D A L L I N S T R U C T I O N S A N D W A R N I N G S B E F O R E U S I N G T H I S P R O D U C T .
This manual provides important information on proper operation & maintenance. Every effort has been made to ensure the accuracy of this manual.
These instructions are not meant to cover every possible condition and situation that may occur. We reserve the right to change this product at any
time without prior notice.
I F T H E R E I S A N Y Q U E S T I O N A B O U T A C O N D I T I O N B E I N G S A F E O R U N S A F E , D O N O T O P E R A T E T H I S P R O D U C T !
If you experience a problem, have questions or need parts for this product, call Customer Service at 1-866-460-9436, Monday-Friday, 8 AM - 4 PM
Central Time. A copy of the sales receipt is required.
FOR CONSUMER USE ONLY – NOT FOR PROFESSIONAL USE.
KEEP THIS MANUAL, SALES RECEIPT & APPLICABLE WARRANTY FOR FUTURE REFERENCE.
CALIFORNIA PROPOSITION 65
WARNING:
This product can expose you to chemicals including lead, which is known to the State of California to cause cancer, and Carbon Monoxide, which is
known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
2 YEAR LIMITED EMISSION-RELATED WARRANTY
THIS ENGINE MEETS U.S. EPA EMISSION STANDARDS UNDER 40 CFR 1054.625 .The emission-related limited warranty is valid for two (2)
years. Keep the purchase receipt and mail in the product registration card for proof of purchase. Buffalo Corp limits emission-related warranty
repairs to authorized service centers for owners located within 100 miles of an authorized service center. For owners located more than 100
miles from an authorized service center, Buffalo Corp will, in its sole discretion, either pay for shipping costs to and from an authorized service
center, provide for a service technician to come to the owner to make the warranty repair, or pay for the repair to be made at a local
non-authorized service center. The provisions of this paragraph apply only for the contiguous states, excluding the states with high-altitude
areas identified in 40 CFR part 1068, Appendix III.
To exercise this warranty, DO NOT RETURN TO RETAILER. Instead, call Customer Service toll free at 1-866-460-9436 (email address
info@buffalotools.com) and you will be instructed on where to take the engine for warranty service. Take the generator and proof of purchase
(your receipt) to the repair facility recommended by the Customer Service Representative. The warranty does not extend to generators
damaged or affected by fuel contamination, accidents, neglect, misuse, unauthorized alterations, use in an application for which the product
was not designed and any other modifications or abuse.
1 YEAR LIMITED WARRANTY
(30 Day Limited for Commercial/Rental Purpose)
Generators are warranted to be free from defects in materials and workmanship for a period of 1 YEAR from date of original purchase. Buffalo
Corp. is not liable for any indirect, incidental or consequential damages from the sale or use of this product. Any implied warranties are limited
to 1 YEAR as stated, or as otherwise stated, in this written limited warranty. Some states do not allow the exclusion or limitation of incidental
or consequential damages. Some states do not allow limitation on the length of an implied warranty. Buffalo Corp will repair or replace, at its
discretion, any part that is proven to be defective in materials or workmanship under normal use during the 1 YEAR warranty period. Warranty
repairs or replacements will be made without charge for parts or labor. Parts replaced during warranty repairs will be considered as part of the
original product and will have the same warranty period as the original product. This warranty gives you specific legal rights, and you may have
other rights that vary state to state.
 
 
1

Advertisement

Table of Contents
loading

Summary of Contents for Sportsman GEN1000I-PL

  • Page 1 Item # GEN1000I-PL 1,000 MAX WATTS INVERTER GENERATOR INSTRUCTION MANUAL R E A D A L L I N S T R U C T I O N S A N D W A R N I N G S B E F O R E U S I N G T H I S P R O D U C T .
  • Page 2: Important Safety Instructions

    Notice Regarding Emissions: Engines certified to comply with California and U.S. EPA emission regulations for SORE (Small Off Road Equipment) are certified to operate on regular unleaded gasoline and may include the following emission control systems: Three-Way Catalyst (TWC) (if equipped), and Engine Modifications (EM). Legal Requirements: Federal and/or State Occupational Safety and Health Administration (OSHA) regulations, local codes, and/or ordinances may apply to the intended use of this generator.
  • Page 3 Flammable Gasoline: This generator may emit highly flammable and explosive gasoline vapors, which can cause severe burns or even death. A nearby open flame can lead to an explosion even if not directly in contact with gasoline. • Do not operate this generator near open flame. •...
  • Page 4 This generator produces powerful voltage, which can result in electrocution. Powerful Voltage: • ALWAYS ground this generator before using it. (See “Ground the Generator” section in this manual). • Only electrical devices should be plugged into this generator, either directly or with an extension cord. NEVER connect a building electrical system to this generator without a qualified electrician.
  • Page 5 Misuse of this generator can damage it or shorten its life. Usage: • Use this generator only for its intended purpose. • Operate this generator only on a dry, level surface. Do not secure the generator with a chain or rope, which would prevent it from being moved in an emergency.
  • Page 6: Engine Switch

    FEATURES: •0.55 Gallon Fuel Tank •1,000 Watts Max/800 W Min AC output •5,000 RPM •40cc, 4 stroke •Low oil shutdown •Recoil Start •Run Time : 6.3 Hours at 50% load •Noise Level : 56db at 0% load @23 Ft •1.3 HP •7.5 ounces Oil •...
  • Page 7: Overload Indicator Light

    2) ECONOMY CONTROL SWITCH When the economy control switch is turned “ON”, the economy control unit controls the engine speed according to the connected load. The results are better fuel connection and less noise. (Turn OFF when using less voltage.) 3)...
  • Page 8: Operation

    Keep open flames away. l CHECK ENGINE OIL Remove side panel, remove oil filler cap and check the engine oil level. Make sure the engine oil is at the upper level of the oil filler hole. WARNING: The generator has been shipped without engine oil. Fill with oil or it will not start.   l...
  • Page 9: Parallel Outlets

    l The economy control switch must be turned to “OFF” when using electric devices that require a large starting current, such as a compressor or a submergible pump. DC APPLICATION This usage is applicable to 12V battery charging. Be sure the Economy Control Switch is turned off while charging the battery. PARALLEL OUTLETS Parallel two generators through using Parallel terminal connecting the special terminal.
  • Page 10: Maintenance Chart

    MAINTENANCE CHART Regular maintenance is important for the best performance and safe operation. Initial Every Every Every Pre-operation Item Remarks 1 months 3 months 6 months 12 months Check (daily) or 20 Hr or 50 Hr or 100 Hr or 300 Hr Spark Plug Check condition adjust gap and clean.
  • Page 11: Engine Oil Replacement

      ENGINE OIL REPLACEMENT 1. Place the machine on a level surface and warm up the engine for several minutes. Then stop the engine and turn the fuel cock knob to “OFF”. Turn the fuel tank cap air vent knob clockwise. 2.
  • Page 12: Fuel Tank Filter

    Install the spark plug. Install the cover FUEL TANK FILTER Remove the fuel tank cap and filter. Clean the filter with solvent. If damaged, replace. Wipe the filter and insert it. Be sure the tank cap is tightened securely. MUFFLER SCREEN l...
  • Page 13: Drain The Fuel

    5. Clean exterior of the generator and apply a rust inhibitor. 6. Store the generator in a dry, well-ventilated place, with the cover place over it. 7. The generator must remain in a vertical position. SPECIFICATION   MODEL GEN1000I-PL Type Invertor Generator AC Voltage 60Hz 120V Max.
  • Page 14 DC Output 12V / 4.0A Model XY139F-6 Type Air-cooled, 4 cycle, OHV, Gasoline Engine Bore×Stroke mm×mm 39×33.5 Displacement 40 cc Max. Output 0.9KW / 5500rpm Fuel Regular Automobile Gasoline Fuel tank Capacity 0.55 Gallon Rated Continuous Operation 6.3 hr @ 50% load Lubricating oil SAE 10W30 Lubricating oil Capacity...
  • Page 15: Storage Instructions

    STORAGE INSTRUCTIONS Long  term  storage  of  your  machine  will  require  some  preventive  procedures  to  guard  against   deterioration.   1.  DRAIN THE FUEL Remove  the  fuel  tank  cap,  drain  the  fuel  from  the  fuel  tank   2.   E NGINE Remove  spark  plug,  pour  in  about  one  tablespoon  of  SAE  10W30  motor  oil  into  the  spark  plug  hole  and  ...
  • Page 16: Wiring Diagram

    WIRING DIAGRAM      ...
  • Page 17            ...
  • Page 18              ...
  • Page 19                  ...
  • Page 20          ...
  • Page 21                ...
  • Page 22        ...
  • Page 23              ...
  • Page 24        ...
  • Page 25 EMISSION CONTROL SYSTEM WARRANTY BUFFALO CORPORATION Your Warranty Rights and Obligations The California Air Resources Board, U.S. EPA and Buffalo Corp are pleased to explain the Emission Control System Warranty on your 2019 model year outdoor power equipment engine. California In California, new spark-ignited small off-stringent anti-smog standards.
  • Page 26: Emission Warranty Parts List

    (2) Any warranty part that is scheduled only for regular inspection in your period stated above. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period. (3) Any warranted part that is scheduled for replacement as required maintenance in your Owners Manual is warranted for the period of time before the first scheduled replacement date for that part.
  • Page 27 (3) Ignition system including: (a) Spark plug (b) Ignition coil (4) Catalytic muffler assembly including: (a) Muffler gasket (b) Exhaust manifold (c) Catalytic converter if available (5) Crankcase breather assembly including (a) Breather connection tube (6) Fuel tank evaporative emissions control system including: (a) Purge valves (b) Carbon canister (c) canister Mounting Brackets (d) Fuel Cap (e) Fuel Tank (7) Miscellaneous items used in above systems including: (a) Switches (b) Hoses, belts connectors, and assemblies (8) Air injection system (a) Pulse valve...

Table of Contents