Page 1
Quick Steps to Start Testing Yealink W80B Step1: Confirm the locations where you want to install Yealink W80B. In this step, you will need a floor plan to find a place where is easy to install the screw and avoid metal walls.
Page 2
1) Change Base to DM-base mode by quick press pairing key three times. When you see the light below, that means it is on DM-Base mode. 2) Long press the Pairing button on W80B until you see the DECT LED slow flash. Now it is on registering status.
Page 3
IP address of DM. Then you will also see the base on registered list. This method is very useful when you are building a small system and it is only supported on Yealink MC product.
Page 4
Step6: Register handsets and account 1) Go to Handset&Account—Handset Registration—Add Handset. 2) On handset, press Reg key to pair to the system 3) Then add assign an account to the handset.
Page 5
Step7: Repeat Step5 and Step6 until your setup all the bases and handsets Please follow the test case to test W80B and share with us the test result. Some tips you may need to know. Enter measuring mode on W56H (W53H does not support this with currently version yet) 1) Dial *1383201# handset.
Page 6
2) Take screenshot of DM-Status page/DM-Handset Registration/DM-Base Station Settings page. Auto provision W80B uses same auto provision mechanism with other phones so that customers can quickly familiar to it. If you want to use auto provision to configure the system, please use the template.
Need help?
Do you have a question about the W80B and is the answer not in the manual?
Questions and answers