Calibrating Your Maslow - MAKER MADE MASLOW CNC Setting Up

FROM THE MAKERMADE LEARNING LIBRARY, SPECIAL THANKS TO USER MADGRIZZLE

1.5 CALIBRATING YOUR MASLOW

TOOLS NEEDED:
Maslow CNC
Router, .25" bit
Safety goggles
Protective gloves
Screwdrivers
Calibration is the step that sets your machine up so it will cut designs accurately.
Calibration is of paramount importance and is probably the most difficult, and
sometimes frustrating, part of owning a Maslow.
there are a lot of varying factors that may cause temporary hiccups.
a break and come back to it.
NOTE: SLED/ CHAINS SHOULD NOT BE ATTACHED TO FRAME AT THIS POINT!
If they were attached previously, remove them before proceeding
Observe proper safety precautions, including wearing safety goggles and protective
gloves especially anytime chains are attached and moving
THIS WORK IS LICENSED UNDER THE CREATIVE COMMONS ATTRIBUTION-NONCOMMERCIAL-NODERIVATIVES 4.0 INTERNATIONAL LICENSE.
Power Drill, .5" bit
Hardware and components
from kit
Computer or tablet
Ground Control software
MATERIALS LIST:
(1) 4x8 plywood, .75" thick*
(1) .5" carriage bolt
Because every user sets up their own frame,
If you do get frustrated, take