MAKER MADE MASLOW CNC Setting Up page 17

18"
SLED BASE
18"
1.5" DIAMETER
CAP
NOTE: These steps are for the Rigid
router, other routers may differ
TOP VIEW
LAST UPDATE 06.11.19
BRICK
HOLDERS
1X5.5"
BOLT
BEHIND CAP
SIDE VIEW
Ring Bracket
L-Brackets
STEP 1 CUT OUT PLYWOOD PARTS
Saw, ruler
• Mark dimensions of parts on plywood
• Exactness is not critical for temporary sled
• Using hand or circular saw, cut out parts
STEP 2 CUT CENTER HOLE FOR BIT
Router, .25" router bit, pencil
• Mark 1.5"x1.5" hole in center of sled
• Use router to cut out hole, going down
approx 1/10" per pass
STEP 3 REMOVE ROUTER HANDLES, BASEPLATE
5/16 allen wrench, screwdriver
• Remove cap on side of handle
• Bolt inside hole may be unscrewed with a
5/16 allen wrench
• Turn router over so baseplate is up
• Use Phillips-head screwdriver to remove 3
machine screws from bottom of baseplate
• Set router and baseplate aside
STEP 4 ATTACH L-BRACKETS TO RING
BAG #8 (6)nuts, (6)bolts, allen wrench
PARTS #6-7 Ring bracket, (3)L-brackets
• Line up L-brackets as shown with
rectangular brackets on ring
• Insert bolts from inside of ring bracket out
through L-brackets, two per bracket
• Secure with nuts, using allen wrench to
tighten
TEMPORARY SLED ASSEMBLY PG. 2