Download Print this page

MAKER MADE MASLOW CNC Setting Up page 14

Advertisement

STEPS 12-14 TAKE PLACE ON THE TOP BEAM OF THE FRAME, REPEATED ON EACH END
FRONT VIEW
FRONT VIEW
LAST UPDATE 06.01.19
SIDE VIEW
STEP 12: INSTALL MOTOR MOUNTS ON FRAME
BAG #4 (8) wood screws
PART #12 X/Y Motor Mounts
• Position motor mounts on beam flush with
front and side edges
• Using two screws per slot on base of each
motor mount, fasten motor mounts to
beam with wood screws
STEP 13: ATTACH MOTORS TO MOUNTS
BAG #5 (8) small screws, (8) lock washers
PART#13 X/Y Motors
• Place one motor in each bracket
• Slide lock washers over screws
• Fasten screws through front of motor
mount into aligned holes in motor
STEP 14: INSTALL SPROCKETS ON MOTOR SHAFTS
BAG#1 (2) sprockets, (2) set screws
Allen wrench
• Insert set screw in hole on side of sprocket
• Screw in slightly with allen wrench
• Place sprocket over motor shaft
• Tighten set screw with allen wrench
ATTACHING THE ELECTRONICS PG. 4

Advertisement

loading

Related Products for MAKER MADE MASLOW CNC