MAKER MADE MASLOW CNC Setting Up page 34

SLED
WORKING SURFACE- SURFACE TO BE CUT
CUT 1
CUT 3
LAST UPDATE 06.07.19
STEP 28: MOVE SLED TO CENTER
• Return to Ground Control screen
• Click MOVE TO CENTER
• Sled should move to center of plywood
• Click NEXT
STEP 29: SET HOME POSITION FOR Z-AXIS
• If Z-Axis is installed, make sure ENABLE
AUTOMATIC Z-AXIS is turned on
• Click ADJUST Z-AXIS until router bit just
touches surface of wood
• If Z-Axis is not installed, adjust bit depth
manually
• Click DEFINE ZERO
SLED
STEP 30: RUN TEST PATTERN
• With router bit at zero, turn router on
CUT 5
• Click CUT TEST PATTERN
CUT 2
• The Maslow will now cut 5 shapes as
shown
STAY CLEAR OF MACHINE WHILE PATTERN
RUNS, IF CHAINS WRAP AROUND SPROCKETS
CUT 4
OR ANYTHING ELSE HAPPENS, CLICK "STOP
CUT" THEN TURN ROUTER OFF BEFORE
TOUCHING CHAINS OR ANY OTHER MOVING
PART
CALIBRATION PG. 9