MAKER MADE MASLOW CNC Setting Up page 15

STEPS 15-16 TAKE PLACE ON THE
STEP 15 ATTACH THE ARDUINO
BAG #6 screws, standoffs
PART #2 Arduino
• Gently remove shield from Arduino
• Position Arduino in center of plywood
• Insert screws through holes
• Slide standoffs over screws
• Screw into plywood
• Re-attach shield
NEXT STEP: BUILDING THE TEMPORARY SLED
LAST UPDATE 06.01.19
BACK OF FRAME
ARDUINO MOTOR & SHIELD
USB CABLE
POWER CABLE
STEP 16 RECONNECT ELECTRONICS
PARTS #1-2 Power Cable, Power Supply
PART #9 USB Cable
PART #11 X/Y Motor Cables
• Attach Arduino to motors with cables
• Connect power supply to Arduino
• Connect USB cord to Arduino
• For more details review electronics
setup guide
BACK
OF THE FRAME
ATTACHING THE ELECTRONICS PG. 5