MAKER MADE MASLOW CNC Setting Up page 32

STEP 21: ATTACH STRETCHY CORD TO FRAME
Bag#1 S hooks 1. Loop stretchy cord around center pulley
2. Loop one end of
stretchy cord to
screw under beam
STEP 23: ADD CHAIN TO STATIONARY SPROCKET ON MOTOR
BAG #1 sprockets
• Grab bottom of "u" of hanging chain, pull up and over nail towards center of frame
• Place sprocket in loop of chain, holding onto sprocket and chain for next step
STEP 24: CONNECT CHAIN TO STRETCHY CORD
• Hold chain and sprocket with one hand, grab s-hook from bottom nail with other hand
• Insert s-hook through center of sprocket
LAST UPDATE 06.07.19
3. Insert S-hook in
free loop on other
end of cord
STEP 22: ATTACH CHAIN TO MOTOR
BAG #1 small nails
PART #3 Chains
• DO NOT CHANGE POSITION OF CHAIN ON
SPROCKET
• Pick up inside end of chain
• Insert small nail through circular piece at
other end of chain
• Hammer into center of beam 8" from end
4. Hook temporarily
to same screw as
first loop
CALIBRATION PG. 7