Function Keys; Led Status; Specifications; Table 3 Leds And Their Meanings - Uniden UIP200 User Manual

Function Keys

There are eight user programmable function keys in the UIP200. Each can be
programmed to one of several functions, for example, 1-Touch Speed Dialing,
Voice Message Access, Do Not Disturb, Mute, or 2-Touch Speed Dialing.

LED Status

There are eleven LEDs on the UIP200 IP phone. Two LEDs are also the fixed-
function keys
HOLD
to show the status of the function while it is used. Another LED, the Visual Ringer
LED, notifies the user of an incoming call. The other eight LEDs are the
programmable function keys; these keys illuminate when they are used.

Table 3 LEDs and Their Meanings

LED
All LEDs
HOLD
/
HEADSET SPEAKER
MUTE
(programmable
button)
DND
(programmable
button)
VISUAL RINGER
!
NOTE
If all 8 programmable keys remain illuminated, refer to
Appendix A for troubleshooting steps.

Specifications

The following specifications apply to the physical interface, power supply, and
speaker.
and /
HEADSET SPEAKER
LED On
The phone has powered
up and is initializing.
N/A
The speaker phone or
headset is enabled.
The mute function is
enabled.
Do Not Disturb mode is
enabled.
A voice message is
waiting.
. These fixed-function keys illuminate
LED Blinking
N/A The phone has
A call is on hold. N/A
N/A The speaker phone or
N/A The mute function is
N/A Do Not Disturb mode
There is an N/A
incoming call.
UIP200 User's Manual
Page 12 of 27
LED Off
initialized.
headset is disabled.
disabled.
is enabled.
Rev. 1.0, © UAC, May, 2004