Basic Functions; Make A Call; Answer A Call; Pre-Dial Function - Uniden SSE33 Series Owner's Manual

Hide thumbs Also See for SSE33 Series:

Table of Contents

Pick up the handset or press the speaker button. The handset sounds a dial

tone. Make a quick test call.

When there is an incoming call, the phone rings and the ringer LED flashes.

If Caller ID function is available for the line, the 'NEW CALL' LED flashes, the

Caller ID number is displayed on LCD and the base will announce the Caller

ID number. If the displayed number matches with one phonebook entry, the

stored name will also be displayed on the LCD. Pick up the handset or press

speaker button to answer the call. After talking, hang up the handset or press

the speaker button again to end the call.

In the on-hook state, key in the numbers and the LCD will display the

corresponding numbers. A voice prompt accompanies the numbers, as they are

being keyed-in. Press the speaker button or press the OK/DIAL button to dial

out the number. While keying-in the number, if you want to delete a particular

digit, press the DEL button.

Pick up the handset or press the speaker button, then press REDIAL/P button,

the phone will automatically dial out the last dialed number.

When keying-in the numbers either in the off-hook or in the on-hook state,

press the REDIAL/P button, the display will insert the character 'P', and a 3.6

sec pause is inserted while dialing out the number.

# The pause can also be inserted into the phonebook number or the one

touch memory.

In the off-hook state, press FLASH button to insert flash time. You can opt to

change the flash time, using the menu. For details, refer to 'Set Flash Time',

page 19.

BasIC FunCtIons

Table of Contents