Installing.the.belt.clip; Connecting.to.the.phone.line; Testing.the.connection - Uniden TRU9480 Series Owner's Manual

Installing.the.Belt.Clip

) Line.up.the.holes.on.each.side.of.the.handset..To.attach.the.belt.clip,.insert.into.the.holes.on.
each.side.of.the.handset..Press.down.until.it.clicks..
2) To.remove.the.belt.clip,.pull.either.side.of.the.belt.clip.to.release.the.tabs.from.the.holes.

Connecting.to.the.Phone.Line.

Once.the.handset.battery.pack.is.fully.charged,.connect.the.telephone..
line.cord.to.the.TEL.LINE.jack.and.to.a.telephone.outlet..

Testing.the.connection

To test your connection, try making a call. If your call connects, the settings are fine. If your call does not connect,
check.the.following:
) Check.the.AC.adapter.cord..Make.sure.it.is.securely.connected.to.the.DC.IN.connector.and.to.a.standard.AC.
power.outlet.
2) Check.to.make.sure.the.battery.is.fully.charged..(If.you.don't.see.the."battery.full".icon,.check.to.make.sure.
the.battery.is.properly.connected.)
3) Change.dial.mode.(instructions.on.page.8).
7