Operation - Hatco GLO-RAY GR Series Installation And Operating Manual

General
Use the following information to operate the Glo-
Ray strip heaters.
WARNING
Read all safety messages in the IMPORTANT
SAFETY INFORMATION
operating this equipment.
CAUTION
Standard and approved manufacturing oils may
smoke up to 30 minutes during initial startup.
This is a temporary condition. Operate unit
without food product until smoke dissipates.
Heating Element(s)
Heating element(s) are controlled either by an
ON/OFF toggle switch(es) or an optional infinite
control(s). To turn each element on, move the
ON/OFF toggle switch to the ON position or turn the
infinite control to the desired setting. If the unit is
equipped with an indicator light(s), the light(s) will
illuminate when the element is turned on.
Allow 15-20 minutes
temperature.
CAUTION
BURN HAZARD: Some exterior surfaces on the
unit will get hot. Use caution when touching
these areas.
NOTE: Dual units cannot be equipped with built-in
infinite switches.
Form No. GRM-0508
All manuals and user guides at all-guides.com
section before
to reach operating
Lights
On models equipped with display lights, move the
light ON/OFF toggle switch to the ON position to
turn on the lights.
Infinite Control
ON/OFF Toggle Switch
Indicator Light
Figure 29. Remote Mounted Control Box (RMB)
(RMB-7 Series Shown)
19

OPERATION