Model Designations - Hatco GLO-RAY GR Series Installation And Operating Manual

IMPORTANT SAFETY INFORMATION
CAUTION
BURN HAZARD: Some exterior surfaces on the
unit will get hot. Use caution when touching
these areas.
Standard and approved manufacturing oils may
smoke up to 30 minutes during initial startup.
This is a temporary condition. Operate unit
without food product until smoke dissipates.
Strip heaters equipped with incandescent lights
that require a circuit breaker larger than 20 amps
for the heat element must have a separate circuit
breaker for the incandescent lights that is 20
amps or less.
To ensure safe and proper operation, refer to the
Clearance Requirements listed in the Installation
section of this manual.
MODEL DESIGNATION
N = Narrow Powder-Coated Steel
No Character = Stainless Steel Housing
All manuals and user guides at all-guides.com
G R A H L - 24 D
Glo-Ray
Housing Type
A = Aluminum
High Wattage
Figure 1. Model Designation
2
NOTICE
Installation of two or more separate units with
less than 3" (76 mm) between housings may
result in premature failure of component parts.
Failure to provide proper spacing may result in
heat damage to electrical components.
To prevent unit failure, do not add a decorative
soffit to hide a pass-through mounted strip
heater.
To prevent premature failure of components due
to excessive heat, remote mounted control
boxes must be installed outside the strip heater
heat zone.
Heat damage to countertop material such as
Corian ® and similar products (other than
stainless steel) is not covered under the Hatco
warranty. Contact the manufacturer of the base
material for temperature limits and application
information before installing the unit.
Use non-abrasive cleaners only. Abrasive
cleaners could scratch the finish of the unit,
marring its appearance
susceptible to dirt accumulation.
Dual Elements
Width (in inches)
Incandescent Light
and making it
Form No. GRM-0508