AEG BPE556220B User Manual page 40

40 www.aeg.com
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Fully open the door.
Fully press the clamping
levers (A) on the two door
hinges.
Close the oven door to the first opening position (approximately 70° angle).
Hold the door at both sides and pull it away from the oven at an upwards an-
gle. Put the door with the outer side down on a soft cloth on a stable surface.
Hold the door trim (B) on
the top edge of the door at
the two sides and push in-
wards to release the clip
seal.
Pull the door trim to the
front to remove it.
Hold the door glass panels
on their top edge one by
one and pull them up out of
the guide.
Clean the glass panel with
water and soap. Dry the
glass panel carefully. Do not
clean the glass panels in the
dishwasher.
After cleaning, do the
above steps in the opposite
sequence.
Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise the
surface of the door may overheat.
A
2
B
A
1