DoAll C-260 NC Instruction & Parts Manual page 11

Instruction & Parts Manual
• wrong installation of protective equipment after maintenance or service ;
• hydraulic or electrical problems due to the producer of the component and not to the producer of the machine ;
• big deficiency in maintenance ;
• modifications or maintenance on the machine without authorization of the manufacturer ;
• use of atypical tools, other than the ones suggested by the manufacturer ;
• use of non-original spare parts, other than the one suggested by the manufacturer ;
• Partial or complete non-observance of the instructions ;
• machine used by uninstructed operators without control of an expert operator ;
• movement or machining of non-typical materials, or oversize and overweight materials compared to the ones indicated ;
• natural calamities, including earthquakes, floods or others which could provoke danger or faults to the machine or its
structures easy to be identified ;
• if electrical , pneumatic or mechanical safety features were partially or completely removed ;
• maintenance while the machine is working;
• when parts of the machine are tensioned using temporary connections, without protection or using faulty materials ;
• a person without experience is within the danger area while the machine is running ;
• a person with experience is within the danger area while the machine is running with the automatic cycle.
It has to be considered inappropriate also when the machine runs without enough surveillance to assure the operator
safety or to assure that the machine can run properly.
Pag.11
Edition A