Uniden UCIS 3000 Owner's Manual page 7

Call id on call waiting speakerphone
Table of Contents

Advertisement

Installation
First Time Installation
1. Connect the adapter. Plug the large part of the adapter
into the wall outlet and the adapter tip to the jack at the
rear side of unit. (Use only 9V DC, 200mA, center positive
Class 2 adapter.)
2. Connect the telephone line cord.
A. To connect without an answering machine.
• Take the new line cord to connect the PHONE jack
of your new caller ID phone to the modular wall jack.
B. To connect with an existing answering machine.
• Use the existing line cord supplied to connect the
LINE jack of your answering machine to the wall
modular line jack
• Take the new line cord supplied to connect the tel-
ephone's jack of your new caller ID phone to the
PHONE jack of your answering machine.
• Set your answering machine to answer the phone
after 2 or more rings.
3. Follow the procedure "Setting Up Your Unit" to set up your
unit.
4 Place the unit on a flat table or mount it onto a wall. If you
desire to place it onto a wall, please use the wall mount
bracket and short line cord supplied to accomplish the
wall mounting.
Wall Mounting
1. Remove the Handset from the Handset Cradle and slide
the plastic Handset Tab (located just below the Hook
Switch) up and out of its slot.
2. Turn the Handset Tab around and reinsert the tab back
into its slot so that the plastic tab extends outward acting
as a hook to hold the Handset when mounted on the wall.
3. Turn the phone over so that you are looking at the bottom
of the phone. Attach the removable Wall Mount Bracket
into the Wall Mount Slots at the bottom of the phone.
The back of the phone should then have two round plas-
tic holes which can be used to hang your phone on the
wall.
4. Once attached to the phone, use the Wall Mount Bracket
to hang this unit on the wall plate in the wall.
If you do not wish to mount your phone on the
wall, the Wall Mount Bracket can be reversed
and installed closer to the top of the unit's base
above the battery compartment during installa-
tion in order to raise the angle of the phone's
LCD when sitting on a table or desk.
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents