Heat Generator Plate; Securing The Burner To The Boiler; Probe And Electrode Positioning - Riello RX80 S/PV Installation, Use And Maintenance Instructions

5.4

Heat generator plate

Drill the combustion chamber locking plate as shown in Fig. 4.
The position of the threaded holes may be marked using the gas-
ket joint supplied with the burner.
5.5

Securing the burner to the boiler

To install, proceed as follows:
 fasten the burner 1)(Fig. 5) to the boiler's door 2) by means
of four screws and (where necessary) 4 nuts M8, placing the
insulating gasket 3) between the two.
5.6

Probe and electrode positioning

Before installing the burner on the boiler, make sure the probe
and electrode are positioned correctly as in Fig. 6.
Electrode
D8616
Installation
2
3
D8611
WARNING
218
Probe
9
GB
145
170
190
D7449
1
Do not turn the electrode: position it as illustrated.
Placing the electrode near the ionization probe
may result in the control box amplifier being dam-
aged.
5- 7
15- 16
Fig. 4
Fig. 5
Fig. 6
20017376