UCL SWIFT ILSINTECH K33A Owner's Manual & User Manual page 5

PRODUCT SAFETY WARNINGS
DO NOT touch the sleeve heater or the sleeve during or immediately after heating them.
The hot surface may cause skin burn.
DO NOT place the Swift K33A in an unstable or unbalanced position. The machine may fall,
causing injury or damage to the Swift K33A.
The Swift K33A is precisely adjusted and aligned. DO NOT allow the unit to receive a strong
impact. Use supplied carrying case for its transportation and storage. The carrying case
protects the Swift K33A from damage, moisture, shake and shock during storage and
transportation.
Replace the electrodes in a timely manner and maintain them as instructed below:
— Use only the device specific electrode.
— Place a new electrode in the correct position.
— Replace the electrodes as a pair.
Failure to comply with above instructions may cause abnormal arc discharge, resulting in
damage to the machine or degradation in splicing performance.
DO NOT chemicals other than ethyl-alcohol (96% or greater) to clean the objective lenses,
V-groove, V-block, LCD monitor and body of the Swift K33A. Use of other solutions can
cause blurring, discoloration, damage resulting in a degradation of performance and
require factory service or repair. The Swift K33A requires no lubrication. Oil or grease may
degrade its performance and damage the equipment.
DO NOT store the Swift K33A in a place where temperature or humidity is high. Damage
to the machine may occur.
Repair and maintenance of the Swift K33A should be performed by a factory trained
technician. Discuss with UCLSWIFT Co., Ltd to use the service.
8 | SWIFT K33A ALL IN ONE FUSION SPLICER
(CONT'D)
K33A SPECIFICATIONS
GENERAL SPECIFICATIONS
SUBJECT DESCRIPTION
Fiber alignment IPAAS Core Alignment
SM(G.652), MM(G.651), DS(G.653), NZDS(G.655), SM(G.657
Applicable fibers
A1, A2/B2, B3), SM(G.654E)
Fiber count Single fiber
Applicable fiber dimensions Cladding diameter: 80~150 um ,
Coating diameter: 100 um – 3mm
Fiber cleave length 250 um: 5~16mm, 900 um: 8~16mm
Splicing modes Splice mode: 300, Heat mode: 50
Average splice Loss SM: 0.02dB, MM: 0.01dB, DS: 0.04dB, NZDS: 0.04dB
Return loss > 60dB (Typical)
Splicing time Typical 6 sec. (Quick Mode)
Splice loss estimate Available
9 sec (IS-45 Sleeve, IS-45 mode), 13 sec (IS-60 Sleeve,
Sleeve heating time
IS-60 mode)
32mm, 40mm, 60mm (Fiber) / 28mm or 32mm
Applicable protection sleeve
(Connector)
10,000 results to be stored in the internal memory.
Storage of splice result
(Image 10,000 results). External SDHC Memory slot
Tension test 1.96N ~ 2.25N
Altitude: 0~5,000m above sea level,
Temperature: -10oC~50oC, Humidity: 0~95%,
Operating conditions
Wind: 15m/s, Non-condensing, Dust proof, Waterproof,
Shock proof
Storage conditions Temperature: -40oC~80oC, Humidity: 0~95%
Dimensions 136(W) x 215(L) x 137(H)mm (Excluding bumper)
Weight 2.45kg (Including battery)
americanilsintech.com | 9