Table of Contents
Advertisement
K33A SLEEVE HEATER OPERATION
As shown in the picture below, press the power button to start the K33A.
CONTROL PANEL
SLEEVE HEATING OVEN
Set the sleeve tube over centered over the exposed newly spliced that needs to be
reinforced and place the fi ber inside the heater. For a connector be sure to set the
connector o the right-most position so that sleeve tube rests in the heater fl oor.
Activate the heater after placing the fi ber. The cooling fan will run to cool the tube 20
seconds after heater activation.
24 | SWIFT K33A ALL IN ONE FUSION SPLICER
Connector
Sleeve Tube
Open the cover when cooling is completed and take out the reinforced fi ber and place into
the cooler tray.
Use caution as completed heat shrink is hot and can cause injury if touched directly.
250um Fiber
900um Fiber
Splice On Connector
Cooling Tray
Splice On Connector
900um Fiber
250um Fiber
HANDLING & STORAGE
Be careful in using, handling or storing principal parts including blades, heater and splice
chamber as neglect can affect the performance of the K33A.
Do not apply unnecessarily weight or physical impact when handling the equipment and
always use the toolbox for transporting K33A.
Keep the principal parts of the equipment clean to ensure consistent performance.
americanilsintech.com | 25
Advertisement
Table of Contents
