UCL SWIFT ILSINTECH K33A Owner's Manual & User Manual page 15

HOW TO CHARGE THE BATTERY
Plug the AC cord into a UL approved outlet and then connect the DC cord of the AC/
DC adapter to the DC jack of the battery. The LED turns to green when the charging is
completed. The battery includes the protection circuit that prevents full discharge and
full charge. The supply of power stops once the protection circuit is activated. In order to
deactivate the protection circuit and resume feeding power, wait about 10 seconds and
connect again the DC cord to the DC jack.
Swift K33A can be charged during operation because the fl oating charging method is
applied. The battery can be also charged with a 12V Cigar jack charger.
28 | SWIFT K33A ALL IN ONE FUSION SPLICER
HOW TO CHECK REMAINING BATTERY CAPACITY
Insert the battery into the battery groove until it clicks. Remove the Battery by pressing
the battery release button and slide it out.
Press Press to check the remaining battery capacity. to check the remaining battery capacity.
REMAINING BATTERY AMOUNT REMAINING BATTERY CAPACITY
(MONITOR) (LED DISPLAY)
5 Bars 5 Bars
4 Bars 4 Bars
3 Bars 3 Bars
2 Bars 2 Bars
1 Bar 1 Bar
No Bar No Bar
It is strongly recommended that the battery be charged once capacity falls to 10 % (1
bar). Below 10% of capacity could have an effect on splicer performance.
REMAINING %
5 LED 5 LED 80~100% 80~100%
4 LED 4 LED 60~80% 60~80%
3 LED 3 LED 40~60% 40~60%
2 LED 2 LED 20~40% 20~40%
1 LED 1 LED 10% 10%
0 LED 0 LED 5% or less 5% or less
americanilsintech.com | 29