Create A New Thermal Stripper Setting; Edit A Thermal Stripper Setting - UCL SWIFT ILSINTECH K33A Owner's Manual & User Manual

CREATE A NEW THERMAL STRIPPER SETTING

Create a new Thermal Stripper setting when you want to customize a setting and store it
for use in addition to your default settings. Environmental or equipment deviations would
cause a user to create a new Heater Mode setting. Factors like extreme cold that effect
the Thermal Stripper performance is an example when a user might need to add time or
temperature to a default setting.
NOTE:
You must fi rst create a new setting and then Edit that setting (see next section) to
change the values as needed.
Select "New" from the Thermal Stripper main menu. This will display the pre-programmed
Stripper mode stored in the K33A memory on the screen. Select the desired Stripper
mode and select "OK". The selected Stripper mode is added to the menu at the end of
stored selections.
NOTE:
Thermal Stripper modes from No 1-13 cannot be added.
66 | SWIFT K33A ALL IN ONE FUSION SPLICER

EDIT A THERMAL STRIPPER SETTING

Edit a new Thermal Stripper setting when you want to customize a setting in the K33A
menu. Environmental or equipment deviations would cause a user to Edit a Thermal
Stripper Mode setting. Factors like extreme cold that effect the Thermal Stripper
performance is an example when a user might need to add time or temperature to a
default setting.
NOTE:
You must fi rst create a new setting and then Edit that setting (see previous section) to
add a new setting as needed.
To Edit a Thermal Stripper Mode setting select Menu from the LCD display or To Edit a Thermal Stripper Mode setting select Menu from the LCD display or
the K33A. Next select Stripper from the menu using the touch screen. Using the arrows
on the LCD display to scroll to the page that lists the setting you want to Edit and select it
on the LCD display. Next select Edit, then select the setting you want to change then edit
again to show the current setting. Enter the new value for the setting and then select the
check mark to confi rm the updated setting.
Select return to go back to the Thermal stripper menu and then ready to return to the
Ready Screen.
from from
americanilsintech.com | 67