Braking System Fluid Top Up - Gilera Fuoco 500ie LT Manual

03_17

Braking system fluid top up (03_18, 03_19, 03_20)

Proceed as follows:
Undo the screws «B» and remove the fuel tank cap «A». Top-up using only the fluid
specified, without exceeding the maximum level.
This procedure applies to the rear brake pump top-up operation; follow the same pro-
cedure for the front brake pump.
To top up the integral braking system brake fluid, partially remove the fluid reservoir
from its mounting, taking care not to detach the pipe. Undo the screw «D» and remove
the plastic cover. Loosen the screw «F» to take out the tank and remove the cap to
03_18
refill.
Under standard climatic conditions, replace fluid as indicated in the scheduled main-
tenance table.
This operation must be carried out by trained personnel; take your vehicle to an au-
thorised Service centre or Dealer.
WARNING
ONLY USE DOT 4-CLASSIFIED BRAKE FLUID. BRAKE CIRCUIT FLUID IS VERY
03_19
CORROSIVE; MAKE SURE THAT IT DOES NOT COME INTO CONTACT WITH
THE PAINTWORK.
63